I have been doing some flavor testing as of late on various hardware. The winner by miles is the Splitfire. I have not used anything else that can even come close to the vapor and flavor on these.
My favorite juices on nova's, T3's, PBC's, Eternity, Stardusts, Hyper SRT's. etc.![]()
My favorite juices in a SplitFire with a 2.8 head at 4.0V-4.2V, priceless.......![]()
Today I'll receive a Birkshire CLR and some 500 mesh. When I get that cookin, I'll see how that compares. But in all honesty I do not see how you can get a denser more flavorful, warm but not hot vape like I am getting with the SpliFire. The only downside, if you can call it that, is my juice consumption has skyrocketed. But I am also getting more satisfaction out of lower nicotine juices.![]()
How do you like your VAMO?
Oh no! Kellie...........time for that black cloud hanging over your to go away!! {{{hugs}}}
![]()
![]()
![]()
![]()
[h=3]GotVapes SplitFire 3ml Tank Replaceable Head 2.4ohm - CLEAR[/h]$12.95
Introducing the Gotvapes SplitFire by TempestTek!
The bottom of the tank holds up to 3ml of ejuice and is separated by the top air chamber by a metal plate with 4 drilled holes for the wicks. Each head has two ~2ml wicks giving you four lead wicks that descend into the juice chamber for extra wicking. This is similar to our Vision Grande 4 wick-lead system.
Fully disassembled you can replace both poly carbonate tanks and coil/wick heads. We have replacement coil/wicks available in 1.8ohm, 2.4hm and 2.8ohm as well as various colors of 2 piece tank covers.
The replacement wick is shoe-lace tipped to allow easier insertion into the plate holes when replacing your wick!
- You will receive one 510 threaded SplitFire Tank with 2.4ohm coil head.
- It is recommended that you prime your wick above the metal plate and allow time for the wicks to fully soak before vaping.
- These were manufactured with an easy to adjust slot-head connector pin. The way these were manufactured TempestTek assembled these with 1/2 mm or so protrusion so you may need to adjust when screwing into your PV.
i keep screwing up punching the wicks thru the holes, my hands shake a lot and i usually ruin one or more wicks b/c of it, any tips?
also if a wick comes out of the hole back to the top is there a way to get it back in without the plastic shoelace tips at the end of the wick?
YOU WIN YOU WIN !!!Hey...whopeeeeeeee! Just saw that was my 1,000th post. Did I win an evic???

