High end RTAs
- Thread starter Yonjuro
- Start date
- th_trl_thread_readers 0
- Status
Im after a second hussar anyway.... so was going to purchase from here (where i got my single deck), Hussar Vapes RTA Nano
You say you was after a microtank @TheotherSteveS they have them there too, if your in the UK guys youll have to message the bloke through facebook, hes a top lad, will happily ship here....
not on FB any more
Its pretty expensive to be honest at 63 eur. 55 on vapstor for example (if they had one that is..) I really want the M2L centre pin though...really? Seems good enough for MTL for me, but then again each to their own!not on FB any more
It is pretty good but closing down the AFC ring is never a complete substitute for
a smaller AF under the coil! You have the GT3 so you can tell the difference right?!?
but then again, I tried the kayfun lite plus and it was too tight! even upon loosening the airflow, guess MTL to me is pretty airy... lol
nope, PM me it and ill send it to him, then you can tell him what you want etc
So the top cap on my skyline is stuck and the 510 adapter from provari is stuck to connector pin (even though I removed the screw) Tried everything freezer, rubber gloves, nothing works. I'm wondering if I should just break the glass to get it off since I have 6 spares. Can anyone offer any advice this is so frustrating.
For stuck top cap, this is the method from Vassilis - remove base, then use your thumb to work it loose by pushing the chimney section up. I had a heck of a job removing it when it had the old o-rings.
I used my own method - a tomato sauce (ketchup) bottle LOL
... put chimney section over the plastic squeeze nozzle, then with rubber gloves used downward force on the glass to loosen it - worked a treat.
As far as the Provari 510 connector, it happened to me on a different atty, you should be able to remove it by screwing applying a little e -juice and allowing to penetrate - then use a vape band around the threads to protect them and carefully loosen the seized ring with some pliers - you could use some WD 40 on the provari ring if it doesn't work. Obviously clean well afterwards.
even the base seems to be stuck also. When I try to remove it top or bottom the glass spins which is making everything more difficult. Which is why i think I'm going to break the glass
ok the eliquid into the provari adapter actually worked... finally off thank u. I'm still struggling with the top cap and base , their both still stuck.
Also in the metal that sticks out on from the base when i looked inside after finally removing the adapter ring i noticed like a film or coating that lines it, is that supposed to be there?
Also in the metal that sticks out on from the base when i looked inside after finally removing the adapter ring i noticed like a film or coating that lines it, is that supposed to be there?
I dont understand what you are on about? If the glass spins the top cannot be stuck?
- Status
Similar threads
