Hit it or Quit it - Butterscotch Pudding (SR)

Status
Not open for further replies.

Kent Brooks

Resting In Peace
ECF Veteran
Apr 24, 2013
17,678
91,969
48
Omaha, Nebraska, United States
www.nicoticket.com
That's alright Clark. I will test on the Genny for you. I can do a Nimbus review, too, if you want. No mesh though.

My RSST gets no action cept for testing... I've been using mesh because I am a glutton for punishment but I am about to retire my mesh.
 

5spike

Super Member
ECF Veteran
Verified Member
Jan 30, 2014
786
2,321
WI
My RSST gets no action cept for testing... I've been using mesh because I am a glutton for punishment but I am about to retire my mesh.
Wondered if you still used the RSST. Mine's been sitting for months, never could get it going right. Too many dry hits. Don't know if I roll the mesh to tight or to loose.
 

Claudia P

Vaping Master
ECF Veteran
Verified Member
Jul 19, 2013
4,137
23,651
Dayton, TN, USA
Steep time:FOB-1 week

Nic Level:6mg

tank/Atomizer: Patriot

Build Information: dual micro coils at 1.1 ohms peaches and cream yarn wick 2 strands.

Mod: (mechanical, VV) Mechanical

Thoughts/Tasting Notes: I decided to put some of this in an Aspire ETs to take with me and put in a new head, did all the priming and let it sit a while, then took a big hit which was a huge mistake. I got a bad bad dry hit which fried my throat and tongue so I am a bit late with this.
My tongue is coming back little by little and while I'm not tasting this at full volume yet what I am tasting is something I really hope makes the cut. I like it enough already in it's muted state, (tongue not juice) to reorder which I will do if any is left when I move into a new CC billing period.
 

Claudia P

Vaping Master
ECF Veteran
Verified Member
Jul 19, 2013
4,137
23,651
Dayton, TN, USA
I needed to build a new coil for my Trident clone this morning and my addled brain decided to try a twisted coil. I don't use power tools so I decided to twist it by hand like I had seen an Oriental gal do in a video once, I used pliers to hold the two cut ends and put the rod from my coiling jig in the folded over edge. I maintained tension and held the pliers tightly while I twisted the rod until it looked about right to me.
Then made a micro on the rod which I think I remember DI saying was 1/16th, I started with 10 wraps but that wasn't quite enough to make the ProVari happy, which is the mod the Trident lives on, so I took it off and did one more wrap which made it 1.1.

With a happy ProVari set at 3.9 volts and the 1.1 ohm twisted 30 G Kanthal single coil I decided to try BSP.

OMG this is good stuff. :) and this appears to be a build/combo that makes BSP very very happy, I know it made me very very happy.
 

Kent Brooks

Resting In Peace
ECF Veteran
Apr 24, 2013
17,678
91,969
48
Omaha, Nebraska, United States
www.nicoticket.com
Steep time:FOB-1 week

Nic Level:6mg

Tank/Atomizer: Patriot

Build Information: dual micro coils at 1.1 ohms peaches and cream yarn wick 2 strands.

Mod: (mechanical, VV) Mechanical

Thoughts/Tasting Notes: I decided to put some of this in an Aspire ETs to take with me and put in a new head, did all the priming and let it sit a while, then took a big hit which was a huge mistake. I got a bad bad dry hit which fried my throat and tongue so I am a bit late with this.
My tongue is coming back little by little and while I'm not tasting this at full volume yet what I am tasting is something I really hope makes the cut. I like it enough already in it's muted state, (tongue not juice) to reorder which I will do if any is left when I move into a new CC billing period.

Great round-up Claudia <3
 

catmomma

Super Member
ECF Veteran
Verified Member
Dec 31, 2013
822
2,564
DC Metro Area
I needed to build a new coil for my Trident clone this morning and my addled brain decided to try a twisted coil. I don't use power tools so I decided to twist it by hand like I had seen an Oriental gal do in a video once, I used pliers to hold the two cut ends and put the rod from my coiling jig in the folded over edge. I maintained tension and held the pliers tightly while I twisted the rod until it looked about right to me.
Then made a micro on the rod which I think I remember DI saying was 1/16th, I started with 10 wraps but that wasn't quite enough to make the ProVari happy, which is the mod the Trident lives on, so I took it off and did one more wrap which made it 1.1.

With a happy ProVari set at 3.9 volts and the 1.1 ohm twisted 30 G Kanthal single coil I decided to try BSP.

OMG this is good stuff. :) and this appears to be a build/combo that makes BSP very very happy, I know it made me very very happy.

Thanks for posting this, Claudia. I've been wanting to try a twisted coil for a while and I thought it would be ridiculous to try and do it by hand. I honestly wouldn't know where my drill is and it doesn't fit into my vape toolbox :D. I'm vaping the BP in a Kraken with XC-116 wicks and it's insanely good. I get every nuance of flavor from this but I want to try a different build to see if its the build or the juice. Your build sounds perfect, gonna try it out.
 

keithu2

Vaping Master
ECF Veteran
Verified Member
Jun 13, 2013
3,114
21,020
Honolulu, HI, USA
How many are REOs filled with NT?

I need to grab a cheapo just for drip testing stuff so my Reo & 2 MVPs can just keep running what I'm in the mood for.


Three: Mini - Radioactive, Grand - the Virus, LP Grand - Naki' Mix
Provari mini w/ igo-w - Wakonda, atomic - BP, kfl+ - Gravity
Stingray w/ tobh - locked, but not loaded . . .

. . . and I feel a cold coming on, so everything is tasting kind of meh. :(
 

AStilettoHeel

Super Member
ECF Veteran
Verified Member
Apr 3, 2014
919
4,366
San Diego, California, United States
Three: Mini - Radioactive, Grand - the Virus, LP Grand - Naki' Mix
Provari mini w/ igo-w - Wakonda, atomic - BP, kfl+ - Gravity
Stingray w/ tobh - locked, but not loaded . . .

. . . and I feel a cold coming on, so everything is tasting kind of meh. :(
Feel better soon! ((((keith))))
 

dave4127690

Senior Member
ECF Veteran
Jul 28, 2013
83
155
Southern California
Thanks for posting this, Claudia. I've been wanting to try a twisted coil for a while and I thought it would be ridiculous to try and do it by hand. I honestly wouldn't know where my drill is and it doesn't fit into my vape toolbox :D. I'm vaping the BP in a Kraken with XC-116 wicks and it's insanely good. I get every nuance of flavor from this but I want to try a different build to see if its the build or the juice. Your build sounds perfect, gonna try it out.

I keep telling everyone XC-116 gives better flavor than cotton, at least I think so, I don't vape with anything else :)
 
Status
Not open for further replies.

Users who are viewing this thread