iatty leak question

[Krang]

Put 2x3/1,8 o-rings around ceramic Hrang.

The 2 orings that go on the ceramic are supposed to be different sizes.

So, they are supposed to be different sizes, but using the same size will do ?.....

Also Thanks for the link, I will get my o-rings there fright!

 

[fright88]

LOL You know it is a little bit confusing. I got 2 different sizes. But if Imeo says to use 2 3/1.8 I would do that.

BTW when I was looking on that site I was able to order enough o-rings for everything in the o-ring guide x5 for like 20 bucks shipped so I would recommend getting a bunch of extras to have just in case.

 

[Krang]

LOL You know it is a little bit confusing. I got 2 different sizes. But if Imeo says to use 2 3/1.8 I would do that.

BTW when I was looking on that site I was able to order enough o-rings for everything in the o-ring guide x5 for like 20 bucks shipped so I would recommend getting a bunch of extras to have just in case.

Yep, I know, I got 2 different sized ones too. Ill just wait for Imeo to reply with definite answer.
Also thanks allot for that website. I am buying like 20 of each o-ring needed for the iatty, and 20 of each of the extra ones that were recommended in the post #98.

 

[imeothanasis]

2x3/1,8 are the right o-rings Krang

 

[Krang]

Ok thanks, I have ordered all o-rings I need.

I will be trying the fix recommended at post #98 and will post updates.

Love this community

 

[BeGun]

Hope these help I had to change coil. sorry pics arent very good

These 2 Pictures are not available.
Can you upload the pictures again please?

Kind regards from Germany
BeGun

 

[imeothanasis]

You put a 4/1,5 o-ring under the center pin BeGun. This o-ring touches the base of the lower plastic

 

[BeGun]

Yesss

It works great and it's no more leaking.
Unfortunately, my wire is now almost empty

Many thanks, i love this forum

 

[eyebrook]

Here are the pics hope they help