IPV 35w and 50w box mods
- Thread starter ainako
- Start date
- th_trl_thread_readers 0
- Status
The only difference is the custom logo as far as I can tell. When I turn it on from changing the battery it resets to 50 watts and it says check atomizer though. I've seen reviews where it resets to 15 watts but mine doesn't.
Ya mine resets to 15 watts, and I've never had check atomizer come up. Mine also doesn't detect shorts though.
my custom 50w finally arrived today
Looks great , shows how clean the build is , now that looks more in the range of black then the one i got. Noticeable gap but imo no biggie , as long as it works.
I bet you paid around the $90.00 to $100.00 range with shipping , the shipping is the killer . On another note my 35 watt detects shorts , i don't take the battery out so i don't know what it resets at .
Once a week a charge it through the USB , i get about a solid weeks worth of run time since i use it mostly in the 12 to 15 watt range.
Once a week a charge it through the USB , i get about a solid weeks worth of run time since i use it mostly in the 12 to 15 watt range.
That's with the center pin screwed all the way down. There's less of a gap with the Magma if I take it out completely and it still works though.
I picked up one of these and they work great , kind of lessens the eyesore of a large gap .
Ya know after seeing your custom model , i actually wish i got one with that hot babe on it lol.
Last edited:
Here's what the Magma looks like without the center pin
It's an Infinite clone btw
It's an Infinite clone btw
It works fine without the pin for my attys with longer 510 connectors but juice could possibly leak into the housing since there's just a hole when you take out the pin
It works fine without the pin for my attys with longer 510 connectors but juice could possibly leak into the housing since there's just a hole when you take out the pin
Nothing on my new IPV would sit flush either -- until I discovered the screw really was not screwing all the way down. Once you think it's all the way down, use a little more force and it will turn more. I turned it about a quarter of a turn tighter and then backed it off. I kept doing that until the screw was really all the way down. Once I got it down all the way I removed the screw completely and blew out the connector just in case there was a burr or something that came off while screwing it down further. Now all my attys sit flush with the screw in place.
I see, I don't know much about the new chip, besides its supposed to go to 100 watts. Interesting that they would change the chips firmware 3 weeks after release.
As a side note, what do the non upgradable chips say when there is a short? Just SHORT, right? Because all mine does is go to 9.9 ohm.
- Status
Similar threads
- Locked
