- Status
Cotton wicks last a long time. They pretty much will last until you need to dry burn your coil, since you have to switch out the cotton anyways. If you vape very clean juices you can go a long time. I know the unflavored vapers go weeks on a cotton wick.
I took my KFL+ with me into a warm (87 degrees) car, and was getting gurgling/flooding. Anyone else experience that? Had to blow it out.
Here's my silica wick/coil. Same wick coil since December 1. 3mls/day.
It's time to give it up! At least throw a new wick in that thing!
But it still hits like a freight train.
Going to taste like licking a freight train if you don't put a new coil in one day
Last edited:
You didn't mention which specific clone you're using. I had problems with the Black edition from the eBay seller (privatedeal2010 I think) until I ignored suggestions for placement and put my coil much higher than suggested. I'm sure I linked to a pic of where I stuck my coil in this thread, just look through my previous posts. Maybe trying this will help. I get at least 4 full tanks on gunker juices now with a cotton wick with the high coil.
Sent from my Nexus 7 using Xparent Purple Tapatalk 2
Going to taste like licking a freight train if you don't put a new coil in one day
Have you ever licked a freight train? Don't knock it till you try it.
Going to taste like licking a freight train if you don't put a new coil in one day
Hey Jerms...have you been vaping/ordering any NETCOM?
No, it's been a while. There's a bunch I want to order though, especially the single varietals.
I get the Latakia and Burley. Makes for a great combo. Wonder how the orders are going out with Clay. Have you heard?
A few people said they got their orders last week. Wait time is still long, but he's pluggin' along getting them out.
The only time I had leakage from my kayfun was bringing it from freezing car (all afternoon) to warm house.
I wasn't sure if this had been mentioned yet or not. I borrowed it from the FastTech Forum:
All you have to do is remove the chimney, chimney base, and the top two sections of the tank.
More pictures.
I get I nice warm vape from it in this mode. The reason for this is because the coil sits right underneath the drip tip.
By the way, it can also hold liquid in the tank if you just want a smaller device.
For illustration, it is just as tall as a Trident with an RSST drip tip on it.
Hope you guys enjoy it.
Update from user experiences:
Use a 2mm rod/drill bit to wrap a coil, and lift it up 1 to 1.5mm from the deck. If you make a bigger coil and sit it up higher, the coil will touch the top cap from the inside.
To get a better dripper experience, remove that airflow control screw completely. And use a drip tip with a big hole (Fatty or ming (RSST style)). This will allow for more airflow, and lower Ω coils.
Stuff cotton into the tank section to create a reduced chamber (Post /w pictures from user Lowtech here)
Don't forget to remove the small o-ring that sits underneath the topcap that slides over the chimney topper!
Thought you guys might get a kick out of seeing this.
All you have to do is remove the chimney, chimney base, and the top two sections of the tank.Does anyone else who has more than 1 kayfun lite plus to compare feel like some are more constricted than others? I just received a new KFL+ v2 and the draw seems really tight compared to my previous ones even when fully open..
- Status
Similar threads
