- Status
Loosen then tighten the cap a few times.
Sent from my HTC One using Tapatalk
Sent from my HTC One using Tapatalk
Are you leaving room for an air bubble? When I tried filling all the way full, it gave me dry hits...leaving a little "head room" really helped.
That seems to be working. Thanks! It was really pissing me off because I finally figured out how to wick both my KFL+ and 91% so they were performing great. I filled em both up, got in the car, and 2nd or 3rd hit: yuck!
I confess I overfilled, but emptied some out when I got to my job. Was still getting burnt, but twisting the cap seems to have gotten the air bubbles out and restored proper vacuum. These puppies are a tad temperamental.
When I fill it, I just fill it from the bottom until I hit the end of the clear tank section. Wicks perfectly.
I've found that when I get dry hits I cover the air hole on the base and gently suck on the drip tip. After I see an air bubble float through the juice, I'm generally good to go. I can't overemphasize the gently part though. Too much sucking gets you flooded.
Master of Bassets...and not much else.
Master of Bassets...and not much else.
Ok. Got rid of the bunt hits, but now the flavor is muted. These things are driving me crazy!
wicking is a vaping form of art. Once you get it down on new devices, it will come.
On the kayfun ive learned less cotton is more, and the height of the coil from the deck airhole is 1.3-1.4mm for my sweet spot. Too high and u get more throat hit and muted flavor, too low and you restrict airflow.
On the kayfun ive learned less cotton is more, and the height of the coil from the deck airhole is 1.3-1.4mm for my sweet spot. Too high and u get more throat hit and muted flavor, too low and you restrict airflow.
I've got the wicking just right. This is not related. It's a vacuum issue. Overfilling starts the problem, then it takes a while to adjust. Both these units performed/wicked beautifully all day till I refilled.
You are on the home stretch.... hang in there.... Sounds like as LR said that you may have too much cotton in the wick. You really are looking for a balance of several variables. This sounds way more complex than it really is, but until you finally do hit that balance, it's frustrating..... patience, Grasshopper, patience.... you will prevail
Believe me, I've done A LOT of experimenting with different amounts of cotton. I do believe I've got the right balance there. I use just enough to gently fill the coil.
Maybe those burnt/dry hits caused ur cotton to become torched causing the muteness. Prob best if u take the wick off, dry burn and rinse in a stream of faucet water dry burn again and rewick... Then next time don't overfill.
Sent from my Nexus 5
Sent from my Nexus 5
I wondered that too, but doubt it. Once I get the airflow right all is well. Flavor is back on the KF+.
I was thinking that too. Once a cotton wick gets burnt, the taste is never quite the same
Burping out loud using Tapatalk
Yes, and post a pic of your build with the wick. Hard to say if it's right without it.
Yeah sounds like you just had too much negative pressure in the tank. Happens from time to time after filling. After I fill, I do the loosen/tighten cap deal a few times and its pretty much good to go for a while if not the duration of the tank.
Sent from my HTC One using Tapatalk
- Status
Similar threads
