- Status
My last Intaste order was monday morning.. They could not ship out to me for 7 days. This was the end of July & they were playing with there new export law & limit. If i had the $ or a need for a 4th LITE, i would order from then NOW. Intaste emailed me and responded to my wanting it now emails, whats the delay.. They even sent me an email on sunday, stating they dont work sundays but were in the office at the time. Great customer service & the best price for the LITE i found. Plus when the package gets sent out Fedex, it is 3 days to my hand. Intaste, great company and awesome service. Dealing with export limits, stupid.
yaa, just swells upper o-ring. let the swollen sit for a few days & it shrinks back down. I was running grenada for 2 weeks... Now i only run grenada in my gennie. I will get around to finding a good upper o-ring, just have not found it yet.
mmikee are you using the clear tank section with the grenada? I only used the ss, afraid the grenada would eat the clear section.
Last edited:
If you find something that work, please let me know. The flavor/vapor from the Grenada/Pluid is just fantastic in the Kayfun.
He's in Canada, eh. The number of Canadian orders is likely much smaller than the number of US orders.
Received my KFL a couple hours ago from InTaste. Shipped via FedEx. Awesome that InTaste still gives out the bag of spare o-rings and screws along with a miniature screwdriver set.
Yeah I had to go look for that bag of goodies yesterday when I lost the little oring that fits on top of the stove pipe. Found the bag and forgot how many free orings they give you. Nice!
Am I using too much cotton? I'm getting a burnt taste from the first few pulls. After flooding the chamber the burnt taste goes away but I don't know how long that'll last.
The picture was taken before I trimmed the ends. Is the density of the cotton too much or not enough?
26AWG, 9 wraps on a 1.5mm drill bit, 0.8ohms
The picture was taken before I trimmed the ends. Is the density of the cotton too much or not enough?
26AWG, 9 wraps on a 1.5mm drill bit, 0.8ohms
Looks ok, its hard to really tell just by a pic, cant tell how densely its rolled or how easily it feeds in the coil
Sent from Galaxy Note 2
Looks OK to me.. As long as the legs were trimmed down quite a bit..
I always get a few dry hits after putting on a new wick and coil.. I usually get a few dry ones when refilling the tank as well but I am using ekowool instead of cotton so that might be a reason.
Last edited:
Might be a little thick and long on the legs. Iput juice on mine so it swells how it's gonna do then I trim the gerth down some and the legs should just sit across ledge. I let mine soak over night not 1 dry hit with cotton.
What I do, is put the evaporation chamber on, without the tinman hat. Then I drop juice onto the wick until it starts to seep out of the intake channels. Then I put the tinman hat on and assemble the rest of the kfl. Then fill and wait about 30 minutes. no dry hits.
its a fine line of the amount and density but once you get it you wont have any issues. this is a couple of pics
that is exactly how I do mine. I used to drip on the coil and wait till it seeped then put the chamber on but this got a little messy if I wasn't fast enough, so now I put the chamber on first like you then drip, then tinman's hat. the only difference is that I vape mine after 5 minutes and its always been good.
- Status
Similar threads
