Some folks have been doing a core wrap for a while, come share your results and experience in the Vcore thread please. All bcc's welcome.
http://www.e-cigarette-forum.com/fo...icro-coil-oddy-kayfun-russian-ithaca-ect.html
RHP
- Status
Some folks have been doing a core wrap for a while, come share your results and experience in the Vcore thread please. All bcc's welcome.
http://www.e-cigarette-forum.com/fo...icro-coil-oddy-kayfun-russian-ithaca-ect.html
RHP
Why did I try sub-ohming God? Now I really need to get a ton of Kayfuns and Nemes. At first the little EVOD/Mini Ego setups I got where surprisingly capable as backup/snack vape devices now they feel absolutely puny in comparison. I used to be able to go a few hours without touching my Kayfun with my rebuilt EVODs but now they are just not doing it for me.
I think I may post the first listing on the classies.
That's funny, I just sold my Altoids mod. I just keep a couple spare tanks with 1.25 and 1.5ohm dual coil cartomizers and juice ready. Was using those in bed as I was afraid my KFL would leak if I rolled over on it while asleep. I've passed out with it for 2 nights in a row now and not a single issue. Just gotta make sure it's all tightened up and it's as bullet proof as any DCT.
Another thread.....
.....ok....ok....I have been eying up knocking the dust off the Terminator and trying something similar anywayNo need to worry about leaks with the KFL. The only times I've had it leak are because of user error like taking a sharp vape while covering the air hole by accident, over filling it or chain vaping it with hard draws over 20 minutes or half an hour hence flooding the atty. If not for those scenarios no matter how I'm holding it, if it's upside down, shaking about, rolling around it will not leak.
Are you sure, that would mean 27volts 810 watts?
Quorax did the vape change at all with the Sony Battery at that resistance. I figured that Sony 30amp would make a difference only when super subohming like .3ohms.
I wouldn't dare go that route Sir, .3Ωs! My limit is .8Ω max
These are the batteries I use on all my mods ~ and they perform nearly the same ~ which is: Wow! And all my attys are coiled at 0.8-1.1Ωs. I only use mechanicals:
Nemesis Kalafan+Kayfun 3.1ES Delta
i'm dressing up my mods for halloween....lol
i'm dressing up my mods for halloween....lol
Got a kayfun lite and I have to say its an incredible atomizer but just not for me. Draw is a bit too tight for my liking. I've seen people drill out their air flow hole but I cant seem to find a place to do it near me. Might just have to put it up for sale, we'll see...
I found the draw a bit too tight as well. You can get the Russian 91% which has air flow control. I left the air flow screw out and the draw is pretty airy which I like better.
Ha! And I think the draw, if anything, is too loose.
I wonder how folks are positioning their wick/coil over the air flow hole.
Surprisingly KFL is actually famed for it's 'loose' airy draw. Ppl have been stuffing it's air-hole with mesh and what not.
Ha! And I think the draw, if anything, is too loose.
I wonder how folks are positioning their wick/coil over the air flow hole.
Goes to reaffirm how different we all are!
That's how I have always heard the general take on KFL air flow...loose!
Nemesis Kalafan+Kayfun 3.1ES Delta
i'm dressing up my mods for halloween....lol
Nice shot ~ very '..... caty'
Edit: What's with the censorship? It was ".....caty"
Last edited:
Never used the Z-Atty Genny Pat. I had the AGA-T+ (that I since unloaded) and I find it near or slightly looser than that. I put the KFL on the loose end of acceptable. But this is no more than my opinion. But with all the devices I have used over my time vaping, KFL has been looser than average.
I find it just fine. Prolly b'coz I maintain/position my coil exactly 1mm above the deck's air channel.
Never had an issue with the draw either. I find it perfect for me. I've never been one to do lung hits, and find the huge air holes on some of the RDA's that folks are setting up very very airy. Are the members that are finding the draw to be a bit tight, lung hitters?!
- Status
Similar threads
