Yeah I couldn't resist. I like the concept for a first tank as you can use Atlantis cartridges then switch over to a KF style rba. Comes with plastic and SS mid sections and a wider than normal KF style 510 drip tip, an Atlantis style 0.5ohm cartridge and chimney, rba cartridge and chimney, keychain screwdriver, silica, kanthal and some extra O-rings.
The RBA vapes well but there are a few things I don't like at all.
1. The RBA chimney is one piece aluminum not SS like the rest of the atty and as seen in the bottom right picture above, a standard KF chimney is two piece and smaller diameter. Also the height is just a little shy so forget a standard KF top fill cap accessory with the included tank and chimney unless you modify it.
2. I really wish the screws were on the other side of the blocks. As is, the coil length is pretty limited unless you use long legs.
3. The posi-post air hole in the KF style RBA "cartridge" is typical KF ~1.6mm. But I was able to drill it out to 2mm.
It does not have side through holes for coil leg capture which I think is a plus.
The chimney for the Atlantis cartridge is SS.
The airflow control ring has detents and one small hole, one larger hole and one mammoth slot.
Juice channels are decent, better than most Kayfuns, not as good as a Russian 91. On par with the Delta II RBA juice channels though air hole on this is much smaller.
After this tank I'll try a quartz tank kit with chimney and maybe a KF top-fill cap.
Just those three things...the aluminum chimney gives me the most concern.
The RBA vapes well but there are a few things I don't like at all.
1. The RBA chimney is one piece aluminum not SS like the rest of the atty and as seen in the bottom right picture above, a standard KF chimney is two piece and smaller diameter. Also the height is just a little shy so forget a standard KF top fill cap accessory with the included tank and chimney unless you modify it.
2. I really wish the screws were on the other side of the blocks. As is, the coil length is pretty limited unless you use long legs.
3. The posi-post air hole in the KF style RBA "cartridge" is typical KF ~1.6mm. But I was able to drill it out to 2mm.
It does not have side through holes for coil leg capture which I think is a plus.
The chimney for the Atlantis cartridge is SS.
The airflow control ring has detents and one small hole, one larger hole and one mammoth slot.
Juice channels are decent, better than most Kayfuns, not as good as a Russian 91. On par with the Delta II RBA juice channels though air hole on this is much smaller.
After this tank I'll try a quartz tank kit with chimney and maybe a KF top-fill cap.
Just those three things...the aluminum chimney gives me the most concern.
Last edited:
