The costs of running this huge site are paid for by ads. Please consider registering and becoming a Supporting Member for an ad-free experience. Thanks, ECF team.

Legacy contact screw

Discussion in 'Puresmoker' started by Xobeloot, Jun 11, 2013.

Thread Status:
Not open for further replies.
Image has been removed.
URL has been removed.
Email address has been removed.
Media has been removed.
  1. Xobeloot

    Xobeloot The Dirty Monkey Verified Member ECF Veteran

    May 29, 2013
    Grafenwöhr, Germany
    I'm finding that if I do not raise this screw before threading on my tank, I am getting a delayed and/or weak fire.

    Is there anything I can do to make it a bit more consistant?
     
  2. CaSHMeRe

    CaSHMeRe Vaping Master ECF Veteran

    Jun 12, 2008
    USA
    Assuming we are talking about the adapter side of things ~ Add the small brass washer from your maintenance kit that came with the LEGACY and it will raise the screw just a tad so you can tighten it down. This will give you some extra length on that side to work with your tank :)
     
  3. Xobeloot

    Xobeloot The Dirty Monkey Verified Member ECF Veteran

    May 29, 2013
    Grafenwöhr, Germany
    Good stuff. Will do that when I get home on Saturday.

    Thanks
     
Thread Status:
Not open for further replies.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice