I would like to pick up some orings for my liquinator (black plastic end caps). I managed to find the oring sizes for the end caps, but have not been able to find the size of the inner orings that fit onto the cartomizer. The standard thread has become so large that it is difficult to find anything.
The two which I purchased have worked fine, but the constant filling gives me cause for concern that I will eventually cut through the o rings since I Dremmel.
My only gripe has been removing the black covering on the cartos I ordered. It comes off easily enough, but the glue is a beast to get off. I have tried acetone, goo be gone, turpentine, but it seems as if you are rubbing forever to get the glue off. The majority of the time is spent cleaning the glue off the cartomizers.
Any suggestions/help would be appreciated.
The two which I purchased have worked fine, but the constant filling gives me cause for concern that I will eventually cut through the o rings since I Dremmel.
My only gripe has been removing the black covering on the cartos I ordered. It comes off easily enough, but the glue is a beast to get off. I have tried acetone, goo be gone, turpentine, but it seems as if you are rubbing forever to get the glue off. The majority of the time is spent cleaning the glue off the cartomizers.
Any suggestions/help would be appreciated.
