The base o-ring is the little white ring:
this might be silly.. but I cant take my driptip off, I wanted to clean it :/
it's super snuggy fit.
Easy peazy... Put the upside-down tank into a shot glass... Boom!
This is the tank turned upside to keep the juice in, and placed in the accessories box that came with the tank. It's a perfect fit, and I almost think it's a coincidence not intentional. I assume it works as well as a shot glass.What are we looking at?
Coincidence it is then! LolThe finger hole is in the accessory box so you can get it out.
I always use spaced coils and they are never perfectly spaced. Just make sure none are touching.
And I still say that there is no o-ring on the base... they are all on the tank.
Thanks Drewbacca96
Just a heads up. I had a few dry hits on this last night and again this morning. I took it apart to try and diagnose and realized that my positive post was quite loose. It is only press fit in and how somehow worked loose, I pushed it back in with a small screwdriver and all seems well now. So if you're getting strange resistance readings or dry hits, check your positive post.
Can you post pictures and tell us the specs of the coil you made?I'm not sure what I did different today when I recoiled my mini but it's working awesome. Big thick rich vapor. Nothing like my first build.
I did two six wrap coils spaced on a 2.5mm diameter. I didn't measure the coils before installing them but they are reading .21 ohms on the mod. I'll try to get a picture later.
You must be using the Mini.