Odysseus official

[gredie]

I just found I miss an o-ring. LOL

At page #56 (?) Imeo mentioned one 11/1 (2) which is listed at the wiki too.
Should i remove this from "Odysseus short mode" chart at the wiki?

 

[fright88]

I believe that o ring is for Ody inside UFS mode which he was origionally going to try to send first shippment.

 

[CarolCrocbag]

Never used an i06, but have used just about everything else and the Ody beats them all; hands down.

Have you tried any of the genesis style atties Para?

 

[Major]

Okay guys, I'm sure this is a noob question but I haven't really noticed it until now. I am using the stock wick and on my last coil, the only difference was I used brother Fright's buffer method with it. Worked a charm and haven't gotten a dry hit so thanks Fright!

One thing I have noticed though is that the wick itself is burned black at the point the coil wire contacts the wick. I am not prepping the wick with a pre-burn but did I wrap the coil too tightly to get the charring or is that just a side effect of no pre-burnin that I didn't notice until now?

Thanks!

 

[Benjalotus]

I think that's normal, make sure you wet the wick before u put any power through it, and even then over time it will still burn the wick a bit an build up a black crust around the coil

 

[fright88]

Okay guys, I'm sure this is a noob question but I haven't really noticed it until now. I am using the stock wick and on my last coil, the only difference was I used brother Fright's buffer method with it. Worked a charm and haven't gotten a dry hit so thanks Fright!

One thing I have noticed though is that the wick itself is burned black at the point the coil wire contacts the wick. I am not prepping the wick with a pre-burn but did I wrap the coil too tightly to get the charring or is that just a side effect of no pre-burnin that I didn't notice until now?

Thanks!

Yes this is normal. Some people have had good luck with dry burns but for me it never seems to get cleaner so I torch it to get it clean again.

Does it look kinda like this?

 

[Rick.45cal]

It's normal Major (at least for me) Mine looks nearly as bad as frights when I go to change it. I don't much do the dry burn thing, I don't even clean my wick anymore, just throw em away and make a new one. I know I could be more frugal, and I was for a very long time, I could make an inch of wick last me 4 weeks. Once I costed out how much each one actually costs me, I realized throwing them away is an ok thing too

 

[nettraxx]

a. 16/1,5 (2). The one around the base, the other around the neck of the body where the big cap goes
b. 9/2. Between caps
c. 2/1,78 or 1,78/1,78. between the metal part that holds the ceramic and center pole
d. 3/2. Under the nut that holds the positive wire

then have been installed to me wrong O-rings
because c + d are the same

 

[imeothanasis]

sure gredie, I agree

Thank you, Imeo. I'll complete the wiki.
I think we have to complete the list when the rest of Odysseus is available.

 

[imeothanasis]

Yes, it doesnt belong to Ody in short mode. It belongs to other Ody modes. I will make a complete list of o-rings when the rest of the parts will be available gredie

I just found I miss an o-ring. LOL

At page #56 (?) Imeo mentioned one 11/1 (2) which is listed at the wiki too.
Should i remove this from "Odysseus short mode" chart at the wiki?

 

[imeothanasis]

I was running out of 1,78 o-rings net so I put a 3/1.78. Its not a problem of course. I just wanted to give the right dimentions of o-rings here

then have been installed to me wrong O-rings
because c + d are the same

 

[fright88]

then have been installed to me wrong O-rings
because c + d are the same

Imeo mentioned that he ran out of the smaller o ring so replaced it with the larget but that it should still work just fince since it's sole purpose is to isolate the center post from the threaded ceramic body.

 

[nettraxx]

I was running out of 1,78 o-rings net so I put a 3/1.78. Its not a problem of course. I just wanted to give the right dimentions of o-rings here

So I had the first time the O-ring squeezed together, but still it is nothing on the sides swell out.
The Ulysses tasted wonderfully delicate and delicious, then I smelled the perfume, previously had a slight cold, then I broke down and Odysseus placed in milk.
With the current assembly I've built the pure O-ring loose, not so pinched, strangely enough, it tastes now fully Tarnave.
Short-term remedy to rotate only the mouthpiece, but a short time later Tarnave taste.
Conjecture: the fact that he was not crushed, everything increased by approximately 1mm, it may be due.

-------------------------
evtl könnte das jemand besser übersetzen als Google es macht.
-------------------------
Also ich hatte das Erste mal den O-Ring zusammen gequetscht, aber immer noch so das nichts an den Seiten heraus quillte.
Der Odysseus schmeckte herrlich fein und lecker, danach roch ich das Parfüm, hatte vorher eine kleine Erkältung, daraufhin habe ich den Odysseus zerlegt und in Milch eingelegt.
Beim jetzigen Zusammenbau habe ich den O-Ring lockerer reingebaut, also nicht gequetscht, komischerweise schmeckt er jetzt voll kokelig.
Kurzzeitige Abhilfe schafft nur das Mundstück zu drehen, doch kurze Zeit später wieder kokeligen Geschmack.
Vermutung: dadurch das er nicht gequetscht wurde, erhöht sich alles um ca 1mm, kann es daran liegen.

 

[gredie]

Yes, it doesnt belong to Ody in short mode. It belongs to other Ody modes. I will make a complete list of o-rings when the rest of the parts will be available gredie

Ok, i modified the Odysseus o-ring chart for "short mode".

Thanks Imeo & Fright.

 

[Para]

Have you tried any of the genesis style atties Para?

Yes....a total of 4.

 

[gredie]

So I had the first time the O-ring squeezed together, but still it is nothing on the sides swell out.
The Ulysses tasted wonderfully delicate and delicious, then I smelled the perfume, previously had a slight cold, then I broke down and Odysseus placed in milk.
With the current assembly I've built the pure O-ring loose, not so pinched, strangely enough, it tastes now fully Tarnave.
Short-term remedy to rotate only the mouthpiece, but a short time later Tarnave taste.
Conjecture: the fact that he was not crushed, everything increased by approximately 1mm, it may be due.

Netttrax, i don't think that you get a burnt taste with Odysseues caused by screwing the pin into the ceramic a bit less to avoid too much squeezing of the o-ring. Yes, the assembly may get a bit higher, but i can't imagine that this is causing burnt taste as long as your wick is long enough on both sides.
I suggest checking the amount of liquid and/or the liquid control (mouthpiece), second check resistance and coil/wick.

In german words:
Wenn Du den Kontaktstift nicht ganz so fest in das Keramitteil drehst, damit Du den O-Ring nicht zu stark quetscht, denke ich nicht, das das kokeln verursacht solange die Glasfaser an beiden Seiten lang genug ist. Ich würde erst mit dem Mundstück/Liquidkontrolle herumspielen und den Liquidstand prüfen. Ansonsten prüfe mal den Widerstand bzw. die Wicklung selbst.

 

[CarolCrocbag]

Yes....a total of 4.

I guess you do not like SS wick for some reason as I believe they beat anything else hands down. More flavour, more vapour and no taint to the taste.

 

[Para]

I guess you do not like SS wick for some reason as I believe they beat anything else hands down. More flavour, more vapour and no taint to the taste.

I'm happy for you.

 

[aleks1502]

imeothanasis.Tell please. When there will be Odysseus second version.

 

[gredie]

What do you mean with "Odysseus second version"? The rest of the parts for all modes of Odysseus will be shipped to the sellers soon - 2-4 weeks.