Odysseus official
- Thread starter imeothanasis
- Start date
- th_trl_thread_readers 0
-
- Tags
- halo madvapes provari revolution
- Status
This.
But regarding the one inside ceramic check if its already there it should be under the nut inside the ceramic.
Thank you once again. I have finally assembled my Ody. And I have built my first coil on it. I'm not very satisfied but I know that it's my fault, because this is maybe my third coil in life, previous two about 9 months ago. Until now I was vaping only on already vape-ready equipment - 510 atty, cartos and clearos. I just need to practice and hopefully one day it will be as it should.
every coil works exellent and immediately Moon. Also maybe it would be better to try the ready wires.
I made my coil with ready wires. But if you have seen my coil you would know what I'm talking about. 
But it is getting better now... I take it again now with my coffee... my biggest problem was metalish taste, I tought that is was because of my coil (it is 1.5 ohm and didn't look well built), but now I'm thinking it was SS taste that I was feeling and that I just needed more time to lose that taste. It's already better and I almost don't feel it any more.
Try taking a lighter to the r section of the premade before wrapping. Gently. Just make it glow a little and pass the lighter across. Also until you get used to wrapping it, use straightened out paper clip with the wick and wrap "snug". Then when you remove clip it should be perfect. Couple times and you will stop using clip. Too loose of a wrap may mean metal taste too.
If single wick, maybe chain vape is not wicking fast enough. Open juice control a little more.
Just a couple ideas.
If single wick, maybe chain vape is not wicking fast enough. Open juice control a little more.
Just a couple ideas.
I got some new ceramics for my Ody v2 from e-smoke the other day, and I am having a problem with them they appear to be too thin at the base, it means that the centre nut will not tighten up on the threaded spindle and therefore will not snug up tight.Anyone else had this at all ?
ceramics are very accurate with a very very small tolerance but maybe yours is faulty. But your problem has an easy solution as I mention before
Ah, that would explain why I had problems with the nut not tightening up for me, Didn't even think to compare the actual ceramic. I had to put one of the little o-rings under the nut to get it to stop spinning. Maybe the changed the ceramic manufacturer or they goofed up on the measurements.
Maybe Imeo can explain what happened.
Imeo beat me to it. But I had the same problem. I thought it was the center pins.
Maybe Imeo can explain what happened.
Imeo beat me to it. But I had the same problem. I thought it was the center pins.
all of the ceramics I got in were different, but like I said, I found a fix with the little o-rings. Now I need to get more of the little o-rings to complete the ones I took from the o-ring sets.
if ceramics were not good then they wouldnt fit on ceramic housing cliff. The tolerance between those 2 pieces is very small. What we care most is the tolerance between the "ear" of the ceramic and ceramic housing. To be sure that all are well, please screw the nut that is inside ceramic on the pin but do it outside Ody. That way you will see if nut screws all the way down to the pin
Thanks Imeo your the man ! I didn't think of thatbut 2 of them are the same maybe all his stock is not too good.
Hello Imeo, just wanted to clarify something you posted about Ody parts not being produced anymore because of Ithakas parts being compatible. Is this true or did I understand wrong. I dont want to "have to " use Ithaka parts in my Odysseus's .
- Status
