These tests were done with 2 volt "sealed" auto shorties with a volt carto at 3.4ohms. Hope no one minds I don't do videos, trying to save as many cameras as possible from my ugly mug.
How do these batts work? Instead of having a hole in the center of the post they have two smaller holes on the side. This doesn't make them unkillable by any means, but makes them much harder to kill. A slight overfill has no affect on them, but a major one could very easily still get juice into the batt itself.
Voltage output on battery 1 was 3.57v on load, and on the second was 3.61v on load. Both right in the range of fault tolerance, and they maintained this voltage until just before the end of life, last puff recorded as 3.23 on batt 1, and 3.21 on batt 2. Average run time of the batts were 175 minutes on batt 1, and 170 on batt two with chain vaping. This is higher than most gen 2 batts I've tried, but will note this is the highest ohm horizontal coil carto I've seen to date, and that does factor in. Each carto from the pack of blanks ranged between 3.3-3.5ohms, which was why I went with 3.4. Now for the big detail...
Draw- In comparison to an unsealed auto with 4 side intake holes the draw is much tighter. Some will prefer this. This one only has two holes around the collar, but even in comparison with an unsealed auto batt with only 2 holes it's still tighter. It's much more like a manual battery. What you give up in draw you gain in protection of the batt though.
All in all, not a bad addition to the volt line up. Think some will still prefer the draw on the unsealed batts in comparison, but for those using the condom method to refill these batteries are a must.
Even if it accomplishes nothing you will know you, at least, did what you could. 
