Orion V2 roll call
- Thread starter tierrataz
- Start date
- th_trl_thread_readers 0
- Status
i drilled mine and its awesome! Yes the draw is a bit more airy but I do direct2lung so doesnt really matter to me.
I didnt loose much flavor while getting tons of vapor
Sent from my GT-I9300 using Tapatalk 2
Just tried to direct to lung for first time and it made me cough lol ....
I remember seeing a genesis type atty that has a juice well on the rebuildable part, can't remember what atty though. It would be nice if this was also done on the V3. Juice from excess vapor condensation can just pool in the well and get absorbed back to the wick or go back to the tank through the fill hole and not seep through the topcap threads.
I've been waiting for almost 2months for vaperwall to let me sign on after registering. Anywhere else to get parts, such as tanks?
BTW: bk78- the Orion is awesome- Thanks man!
BTW: bk78- the Orion is awesome- Thanks man!
Lol. I'm glad you like it man. Contact Kathy at bedazzle here on ecf. She has tanks for you. The size you need for that one is 20mm I measured it before. $10 she charges. And contact emonty here on ecf as well he helped me out on vaporwall.
Kathy's FQ tanks are the best. I currently have a 18.75mm +/- tank on mine. Stock cap air hole hits right in the middle of the wick. The tank seats perfectly on the top oring.
I had ordered one 18mm (far too short), one 19mm (what I sanded down to custom fit) and a one 20mm (didn't use it) tank a month ago or so to see how low I could get a tank on the Orion to lower the stock cap. I ended up using the 19mm one and wet sanding about .25mm +/- off of it to line my air hole up. I was using a slightly sanded 21mm FQ tank (probably around 20.75mm). So I lowered my air hole 2mm roughly.
See how far the tank was above the oring in this picture.
And how even the tank is in this picture.
I'll run my Orion dry tonight and take a picture with each tank on there.
I had ordered one 18mm (far too short), one 19mm (what I sanded down to custom fit) and a one 20mm (didn't use it) tank a month ago or so to see how low I could get a tank on the Orion to lower the stock cap. I ended up using the 19mm one and wet sanding about .25mm +/- off of it to line my air hole up. I was using a slightly sanded 21mm FQ tank (probably around 20.75mm). So I lowered my air hole 2mm roughly.
See how far the tank was above the oring in this picture.
And how even the tank is in this picture.
I'll run my Orion dry tonight and take a picture with each tank on there.
Last edited:
Was it the Vaporwerks "Stratus"? I have one and it does have kind of a juice well that directs the juice back into the tank. It is the best atty!
http://www.e-cigarette-forum.com/fo...s-rebuildable-atomizer-full-specs-photos.html
Hey cracked I sold him the orion v2 and have ordered tanks for it. For the air hole to line up with your wick you need a 20mm Carl
Oh I didn't know that. I thought it was excess unpuffed vapor left in the chamber that condensed back into juice.
Coil/wick setup not right in what way?
Nope. Not that one. It had a raised lip on the edge so that pooled juice won't go to the top cap thread.
- Status
Similar threads
