Penelope official and tips and tricks
- Thread starter imeothanasis
- Start date
- th_trl_thread_readers 0
- Status
thanks a lot imeo my order just got confirmed...!!!thanks i just contac him...
My penny is getting very hot using a 2.6 ohm coil ait 4.8 volts y is this happening?
Sent from my GT-P7310 using Tapatalk 2
Sent from my GT-P7310 using Tapatalk 2
I have 3.5mm wick doubled up on top using 30gauge silber and 32g kanthsl wire?
Sent from my GT-P7310 using Tapatalk 2
Sent from my GT-P7310 using Tapatalk 2
sounds like a short , is the coil stable 2.6 ??? chek it several times might be shortting
its normal glaus. Penelope is thin and an all metal construction so in case of chain vape it will get hot
thanks imeo for the responspe . I rebuilt my coil to a lower ohm coil and it still gets hot but not as bad. I think I had a short before. Can not wait to get my Ithaca I love your devices!
. I rebuilt my coil to a lower ohm coil and it still gets hot but not as bad. I think I had a short before. Can not wait to get my Ithaca I love your devices!Isit normal for penny to slightly change resistnce depending on where juice control is set? Totslly closed it get 2.2 but when open 2.4?
Sent from my GT-P7310 using Tapatalk 2
Sent from my GT-P7310 using Tapatalk 2
if the mouthpiece touches the connections or the coil or budges the coil a little bit it is normal. Happened to me more than once when i am doing fat coils.
Chain vape remind me of your video of Penelope Imeo he he
I am silent admiring you products from germany.
I just bought a Penelope used and it did not come with any wire or wick. I decided to try and use what I had which was 32 Kanthal and 3mm Hemp wick. I double braided the 32 kanthal together and did a four wind of the coil and wired it up without any resistance wire. It comes up with a low 1.2 ohm resistance, massive vapor and no burning taste at all. I am thinking that possibly the hemp wick is less likely to burn than cotton or silica? It does heat up a bit which I imagine would be reduced by adding non-resistance wire. Do you see any problem using this setup in the future. Next time I will add a few more winds to get the resistance up to 1.5 to 1.8 range. Have run three tanks at wattages as high as 15 watts with no problems, dry burns or any problems. Simply Awesome!
I use cotton wick and have good luck with it. Where did you get hemp at?
From this dude on Ebay : Click Here It's cheap and he sends it out fast. It's not wax coated or zinc cored like a lot of hemp wick is. I boil it and the microwave it first to remove impurities, then it's good to.
- Status
