Had it 2000 setting. At least from the board to the black connectors it seemed good but I'm not positive. The board still powers on.
Had it 2000 setting. At least from the board to the black connectors it seemed good but I'm not positive. The board still powers on.
I assume the fire switch is good as it powers up the mod wouldn't you think. If the connection to the black connectors are good I would think I'd have to make sure the connection in the top cap are good to that connection. I'm not sure how I'd test the 510 assembly.
With it set to 200 I'm getting good reading to the vertical connector (if that makes sense) for both the positive and the negative for the 510 assembly
Disconnected the up and down tacts. Made sure the device is as snug as humanly possible. Got the new negative lug and installed that. 510 nut is snug as well. Still cannot get anything to fire again.
View attachment 422387 View attachment 422388 View attachment 422389
Yes it does. It just won't detect or fire the atty anymore. Did a few times but when I tried to put everything together it was issue after issue.
Did it say check atomizer on the screen when it wasn't working?
If it did, based on everything else we have gone through so far, it sounds like maybe you just needed to raise the positive screw in the 510.
On a couple of occasions I have had that screw thread itself too far in when screwing an atomizer on and off a few times. On my 3.1 that is.
The atomizers I'm testing don't sit close to being flush. If anything I'd think the screw needs to go down further. I might just try sending the board back and starting overOr the ground is not fully grounded.
Kurrupt, let's walk slowly through the symptoms,
1. the board display turns on when the fire button is pressed
2. When pressing either the up or down switches, the display shows watt movements accordingly
Fill in the blank
When the fire button is kept on, the display shows:_____________