Problems with my triple coils...

[BK_Malik]

I can't get any decent vapor production or flavor from my triple coils. Is there a particular voltage that I should be using the at? I'm using my Provari and I can't find a voltage that they'll work on. Not happy...

Also, should i be able to see through the hole on my DCT punched cartos? I heard that they are less likely to flood and have better air flow if you can see through the holes to the other side.

 

[keduco]

Do you get an E2 error on the Provari when you try to run higher voltages? Triple coils are great at 5-6v, but unfortunately the Provari's current limiting safety sensor does not allow you run them at those voltages.

 

[Bigbuyer]

Triple coils need to run at 5 or 6v. As Keduco said, the Provari has trouble with dual and triple coils since they are Low Resistance. If you go above 3.8 or 3.9v it will error out. Let me know if you need any further help with this...send me a PM.
On the DCT cartos. The holes just need to be open to let the juice in. I have had great success with large or small holes.

 

[zaino]

Triple coils need to run at 5 or 6v. As Keduco said, the Provari has trouble with dual and triple coils since they are Low Resistance. If you go above 3.8 or 3.9v it will error out. Let me know if you need any further help with this...send me a PM.
On the DCT cartos. The holes just need to be open to let the juice in. I have had great success with large or small holes.

That's what's holding me off buying a VV mod, the amp limit. Is there any VV mod that would vape dual coils or triple coils?
What do you use with triple coils?

 

[Bigbuyer]

I use them at 5 or 6v on a GG or other big battery mod.

 

[seanmc]

That's what's holding me off buying a VV mod, the amp limit. Is there any VV mod that would vape dual coils or triple coils?
What do you use with triple coils?

The vv Sabertouch can handle 25 amps with the "high power" option...most vv's limit to 2.5 or 3amps.

Sent using Tapatalk via Android

 

[Killjoy1]

Infinity and Buzz are both good for 1.5 ohm DC and TC cartos, you can get up to about 4.7 volts with them on those (roughly 3.3 amps before the regulator cuts out). If you need higher, the ST mentioned above is a good VV option.

 

[Chris Braddock]

vporcore shans mod i run dual and triple coil all day at 6v very nice vv box mod