Protege switch

[Fishman7]

Cas do you have any of the old style switches for a protege i just bought a older used unit and it hits better than my new unit ????

ive cleaned the new unit ive 180' the internal contacts on my switch but it seems i still have to apply too much pressure to get it to fire
how ever the older unit switch is easier to fire off ie less pressure and hits better 8-o

 

[gigabitfx]

im having same issue with prodigy v2 here. ive replaced the little rubber band with a modified o-ring, however i still have to rock the switch to make it fire. im about to solder on the two contacts to raise them up just a bit, but will hold off until i cant take it no more, which is getting close =)

when the thing fires though it hits tremedious, so i cant just put the device down over this issue. however the issue i find almost makes the device unusuable for daily use. in fact my thumb is starting to callice, lol.

 

[gigabitfx]

nevermind, i followed the troubleshooting guide here and was able to fix my issue, phew =)
http://www.e-cigarette-forum.com/fo...2-protege-troubleshooting-guide-pictures.html

more specifically, i had to turn my posts from flat to round edge. button no long requires special method to function correctly.

 

[CJsKee]

I tried to turn my posts but couldn't...is there a trick to it? I used needle-nose pliers but they just kept slipping off.

 

[gigabitfx]

same thing was hapening to me, i was squeezing to hard. squeeze enough just to grab and it turns real easy. do both top and bottom

 

[harpo]

Pust the contacts out with a screwdriver from the inside. Then you can put them back in round side up.