heres my original post in newbie forum
hi folks new to this forum stuff but here goes ive been
vaping for three years i just got rx200 which i bought to save me having to keep replcing batteries 3-4 times a day in other mods.
im a chain vaper on low settings not a cloud chaser.
i have been using the rx200 with an aspsire nautilus mini with 2.1 or 1.8 coils and a protank 1 tank with 2.5 coils at 3.5 - 3.8volts set at 5 - 6 watts and 3 x efest 3000-25amp bats and this mod gets warm after about 1 hour and just continues to get hotter and hotter until it hits the temp cut-out which is reportedly around 70 degrees acording to the info. its the board and the body that is heating up.
to my surprise the batteries are not heating up and remain cool. i know efest batteries have a bad rep but i use them all the time and had no problems. and checking the voltages of the 3 bats with the built in voltage balance checker on the mod they stay well balanced unusage and state of discharge.
i use the same tanks and batteries at the same settings on an inikon mvp, inikon vtr, oniyo 30wat box mod , smy 35wat box mod and even an old lavatube
v2 and have never had any of these heat up above normal hand temp.
the only saving grace with this mod is that it does cut-out when it gets hot and wonder if most of the people who buy these mods are using the higher wattages have picked up on this possible fault with this mod under constant heavy use at low settings as most cloud chasers would only be using if for short bursts of time.
i would like to know if anyone else has this problem.
