Wadda bonehead I am.I split my wicking and fed each side over so that it sits right under the holes. Just seemed like the thing to do I got no leaking on my first try.
I just realized I was answering this for the wrong rba.
Wadda bonehead I am.I split my wicking and fed each side over so that it sits right under the holes. Just seemed like the thing to do I got no leaking on my first try.
If you dont use the micro usb just clip the wires and get rid of it. Just make sure to install updates or whatever it is that you may need from escribe befor cutting the cord...I only use wattage but if your into the temp control thing then just tape away.Hi all,
have a question if any of you can assist it would be greatly appreciated.
I want to put some authentic inners on my SXK bb, this obviously means there is no USB port on the inners.
Does anyone know where would be best to put some electrical tape to stop shorting and also allow the inners to fit?
thanks
I just took mine apart to rewick it after about 2 and a half tanks. Like I say, low power mtl tc.How do you find the condensation build up? I stopped running my supbox in BB mode with a Vapesnail because the condensation was so bad. Also felt like the af was too constricted with the way the abs cage doesn't really allow direct airflow. Kind of wooshes in from all the little cracks and gaps
Sounds like I'm pretty much at the opposite end of the BB spectrum. If I'm using a Boro I normally vape a Xeta wide open/RDL with a little 0.4 to 0.6 Ohm fused clapton at around 25 to 30W. Pretty steamy.I just took mine apart to rewick it after about 2 and a half tanks. Like I say, low power mtl tc.
So help me friend, this is what it looked like when I pulled the boro.
View attachment 925625
What about the very thin wire thats used for the switch and buttons any clue what gauge or type of wire is best?I was thinking that Fatdaddyvapes had it but has no 16 or 18
SHOP
Here's some 18:
BNTECHGO 18 Gauge Silicone wire 5 ft red and 5 ft black Flexible 18 AWG Stran... 799705989429 | eBay
30 AWG Gauge Stranded Hook up Wire Kit 5 FT EA 8 Color Ul1007 300 Volt for sale online | eBayWhat about the very thin wire thats used for the switch and buttons any clue what gauge or type of wire is best?
Also those anyone know a source for the up and down buttons switch? I burned a pad off mine while rebuilding the gold BB. Its been a nightmare...
Sent from my SM-G950U1 using Tapatalk
Thanks again my friend
I don't believe those are silicone, still probably OK.Thanks again my friend
Sent from my SM-G950U1 using Tapatalk
Thanks, added to cart to purchase...I don't believe those are silicone, still probably OK.
Here is some that is silicone:
30 Gauge Silicone Wire Kit 10 Color 200 deg C 600V Total 100 ft Each Color 10 ft 742271698080 | eBay
How about a photo of the atty/box? Not the BB, the BoroJust got the SXK Evl Alien. It’s really a tight fit inside the BB. I managed to put it once. But when I got it out to work on my coil I can’t put it back. Help..anybody?
Sent from my iPhone using Tapatalk
How about a photo of the atty/box?
Victory!! I just pressed upwards a tad bit and it worked!!
Sent from my iPhone using Tapatalk