"My" Personal preference is the Bridge with BVC Coils (so easy & really nice), however if Ya' have a lot of carto's available that "You" want/need to use up - I find an extra punched hole/s help with the draw . . . Just Sayin' . . . 
I'm in! Snagged a nice bright green one. TMNBB. Also picked up the Billet Bridge Nautilus. Need to research as I'm not 100% as to which Aspire coils I can use with that.
I'm in! Snagged a nice bright green one. TMNBB. Also picked up the Billet Bridge Nautilus. Need to research as I'm not 100% as to which Aspire coils I can use with that.
Good job!!!
You can use the Nautilus coils, and the Triton Mini coils.
Make sure they say NAUTILUS BVC. Such as:
Nautilus Replacement Cotton Coils - *BVC* - 1.8ohms - 5 Pack
You may want to shop around, but those are the correct coils. Be careful not to get the "X" ones by mistake. Nautilus BVC only.
Will do and thank you. I am familiar with those coils from my Kabuki and Nautilus tanks.
LMAOOOOOOOOOO!!!!!My wife will wonder why she gets flowers later today.
I can't fathom this at all. 1.9? I agree with DPL on this one and would recommend testing that batt on a good multi-meter.
That just sounds so off to me.
Do you by chance have a Provi to perhaps test it on?
I'm gonna run mine down too. I'll throw it on a Provari 2.5 when it's done. I'll report back.Ill run the battery again and check it with multimeter.
Thanks! And... Maybe not.. It is a Unicorn after all... Haha.Congrats on the TMNBB and the Ratbald!
![]()
Does anyone have experience with the VVTF rebuildable Nautilus heads? I have a couple on order and plan to use them in my BB, and also in a Kabuki .. any tips or tricks appreciated.
Did you experience any improvement or decrease in flavor? any problems with juice flow or connectivity? does it need any finagling to work with the billet bridge?I have one and its tiny. Which for me is a struggle. I used for a while but I went back to rebuilding the normal nautilus coils. A simpler method and a consistent result.
Did you experience any improvement or decrease in flavor? any problems with juice flow or connectivity? does it need any finagling to work with the billet bridge?
I experience the same situation. I use a cheap magnifying headgear, and so far it seems to work fine. I wonder about securing the coil head to make it solid whilst building... maybe a vice would serveI should add that my eyesight is not the best so even with a magnifier......it's tricky
I experience the same situation. I use a cheap magnifying headgear, and so far it seems to work fine. I wonder about securing the coil head to make it solid whilst building... maybe a vice would serve
Does anyone have experience with the VVTF rebuildable Nautilus heads? I have a couple on order and plan to use them in my BB, and also in a Kabuki .. any tips or tricks appreciated.