Guys, I feel like an idiot. Didn't reallize that the Stealth Cap ring was a ring 
- Status
Hehehe. I kind of had a hunch about that, Huffel 
Don't fret, we learn something new everyday
Don't fret, we learn something new everyday
Thanks for the "GG for Dummies" lesson again. The Kick is fitting nicely now - took your advice and using stealth cap w/ o bottom button spring.
Indeed, with an 18650 the bottom threads of the telescopic section are exposed a bit. I run mine with 18490s and 18350s though.
Mine's not looking too bad. The most embarrassing part is that I've only used my iAtty with my GG in stealth mode cause I thought that the stealth cap was 1 piece. I can't believe that I didn't see that.
Just got home and my Kick was waiting for me. With my GGTS and my ODY this thing KICKS some ... WOW or WOW
Guys, I feel like an idiot. Didn't reallize that the Stealth Cap ring was a ring
Some time ago, when I received the Stealth Brass Cap for my GGTS I thought it was a one single piece also
. I was affraid to try to unscrew it 
And when I received the ss Stealth I wanted to use the brass Stealth ring in place of the ss ring, to have a combined look, but I couldn't screw the brass ring in the ss Stealth cap (it didn't fully screw in), Imeo told me to screw and unscrew, screw and unscrew until it get fully screwed in. The process took me 45 minutes and some blisters... I think I have learned thath the Stealth cap is composed by two parts
Last edited:
So far it barely fits in my GGTS diameter wise. Using a dual coil carto with control tank I cannot fit a 18650, I had to use an 18500. I'm using the battery spring in my GGTS, it might fit if I take that out but it would probably still be showing a lot of threads. So I have it turned all the way up with a dual coil and the voltage is reading 3.86v. Not a good start...
what ohm's is that. you are maxing out the watts. How is the vap production? I am doing a 2.2 ohm coil in my ODY and I am only running three quarters turn.
I'm using a dual coil at 1.7Ω and it's putting out 3.86v so that's roughly 8.7watts. Tested the carto on my Provari for the Ω and it's 1.7Ω, if it was 1.5Ω then that would make more sense.
Wow really......I have not tried anything under 2.0 yet. Wish I had a way to check the volts but I don't
What's the amperage cut-off on the Kick? Watts are extremely helpful, but only to the point that the amperage (current) is available to deliver. So you're getting 2.26 or 2.27 Amps with that setup....it could be perfectly normal (as designed) since I don't ever remember the Darwin pushing past 2.2 Amps on the display, despite the "12.7W" limit.
GGTS ODY UnKicked
GGTS ODY Kicked
Awesome Rig
Question is... What battery do you have in there? 18500 or 18650?
Nate aka Darth Vapor
Sweet! My SS GGTS's are stock, but I do have a Brass Stealth Cap just in case I need more room
Hopefully I will not need it, but I am Stoked to get this and run it with an AW IMR HD 2000 Battery. Nate aka Darth Vapor
- Status
Similar threads
