The Power of LR Vaping on RBA and Ceramic Wick!

[niczgreat]

I've gone from the 36mg s down to 9mg since switching to RBA.

Previously I was vaping on Vivi Nova or Kanger T3 at the normal range of 4-4.5V and I was vaping in the high 30mg level.

Than I switched to a VV Bogger Box Mod and a Reomizer and started vaping .7-.9 Ohm at around 4v-4.2V
By the way, I started on 400SS Mesh and have moved to Braided Ceramic Wick.

I've reduced my nic down to 9mg and probably will end up at 6mg. You just get so much vapor with my setup that higher MG liquid was getting me jittery.

It's funny the Ohms Volts Charts just don't apply to RBA. I use 28Gauge and the surface area and the wicking is so far above stock solutions that you can go lower OHMs and Higher Volts and enjoy a great vape. I owe it to what was said in 1 post, it's all about the temperature of the wire. With my setup their is surface space on the wire and my wick is absorbing heat, this translates to the ability to go above the charts with no ill effects. Also my Wire is Thick so I can dry burn it.

It's amazing on the Ceramic Braided Wick, I do a dry burn and after the burn the wick turns absolutely white, and taste is super clean afterwards. Total opposite of other wicking materials.

That's the power of RBA LR Ceramic Wick Vaping!!

 

[Symbolik]

Where do you get your ceramic wick from? Ive always wanted to try it but it seems impossible to find. and LR is awesome I justgot a .8 wrap and was surprised to find that my evic could even read it

 

[niczgreat]

I bought mine at SNG Vapor I think it was over 1/8 inch thick
They have a waiting list and you register the email with them and they'll email you when in stock.

I missed the first go around because it was sold out within 2 hours of the email.
But got it on the second.

I also signed up for the list at
Big Tex and they emailed me that it was back in stock
and they had a new wick which was only 1/32nd width.
That will be coming later in the week.

I believe my wait time was around 1 week to 2 weeks.

The SNG Vapor Wick was too thick to fit in my A7 [Going through middle] and had to be set up on side. I'm hoping the thinner will fit in a middle normal type of setup.

Both of these companies are Kiln Treating to remove sizing.

Yes it's expensive but you don't need much. On my A7 I only used maybe 3 inches and it wicked from the bottom very strongly.

My Reomizer only uses about 1/4 to 3/8 of an inch.

Also it's supposed to last months.