The REACTOR Atomizer Tank!!!
- Thread starter Drewsworld
- Start date
- th_trl_thread_readers 0
- Status
Hey Drew,
Where any things chanced about these tanks or is it the atties and the new fill method that alleviate any leaking?
Where any things chanced about these tanks or is it the atties and the new fill method that alleviate any leaking?
I mailed out your tank yesterday with a new Tube and newer atomizer. The atomizers and tubes are different with these. Thanks for your patience.
Drew
Drew
Thanks Drew, I got it today and so far so good, you are the best and you stand behind your products .
just one qustion, is the atomizer spouse to stick out from the bottom about 2mm, it's not flush with the bottom of the tank,
do I need to order another tube to make up for the deference , or this how it should be
just one qustion, is the atomizer spouse to stick out from the bottom about 2mm, it's not flush with the bottom of the tank,
do I need to order another tube to make up for the deference , or this how it should be
Ok im confused. Drew i misread your post about ordering with the inventory glitch yesterday. I thought you meant to just to order the dual coils and put a note in with the special instructions which i did but i just received a confirmation email that said the dual coil was shipped. Just wanted to double check that i am getting the right thing.
Erp...um...Drew, you're going to kill me. I'm a germaphobe and you vaped that tank in your video.
Um...er...I guess I should have told you before hand...remember I wouldn't take a pull if your Darwin at vapefest haha.
You said "oh, you're one if those!" I get that all the time.
I'm pretty sure you don't have the atty pushed in past the upper o-ring. When you put the top on, you need to push (and twist) the atty so that the lip moves past the upper- o-ring.
If you press hard it will go all the way in...It dosent matter much though as long as its snug. Thanks
Your all set, I caught it...You owe me a buck
I remembered you were one of those guys and sent you a brand new shiny one..Actually I didnt feel like washing it out and had Aisa send you a new packaged one. I also didnt have any of the new tube lengths in green so I sent you a clear...Thanks for your patience...
Also as a quick note...Im not sure I emphasized in the video. to hold the tank on its side so the hole is NOT submersed when you blow out the excess...I have found that this is really important...Also leaving these sit unused for long periods Can cause them to leak a little...
Drew, just so I have this straight I will need a new tube to run the single coil atties? Or do I need a whole new Reactor?
You need a new tube, which comes free with the single coil atty, for those that have already purchased the reactor with the dual coil atty. Hope this helps.
That is correct...Well actually the new attys is ten dollars with the tube...
Reactor Tank Replacement Tubes with Atomizer
Reactor Tank Replacement Tubes with Atomizer
Ok. Thats not a problem as I have bought a length of poly propylene tubing and will be cutting my own. Just making sure that the atties will fit. Thanks guys
I think you send it back to me with the new atomizer and the old tube, it is a little short, that why it will not go all the way to cover the whole atomizer
Well I FINALLY had to break down and pick one of these bad boys up. Also threw in an extra atty/tube combo.
Thats exactly what I thought, so I got 2 as well. Very nice deal.
- Status
Similar threads
- Locked
- Locked