The Womper Woom, Womp it again Sam.

Status
Not open for further replies.

Boden

Vaping Master
ECF Veteran
Sep 7, 2012
5,516
28,164
Lexington KY
Thanks. In aerosol considering the blue flame prolly a big whoosh. And at least singe all my hairs.

PG might work in a Kerosene lantern?
I don't see why it wouldn't.

Vg burns as well it just has a higher ignition temperature and burns even hotter.
 
Last edited:

Boden

Vaping Master
ECF Veteran
Sep 7, 2012
5,516
28,164
Lexington KY
Boden, all this makes me wonder if PG?VG in a tank/dripper on a mod with a stuck firing mechanism would flame or poof?
Most likely just smolder the cotton. The air/fuel ratio would be wrong for ignition.

If you took the cap off while the coil was still glowing it would just flame up.
 

Robert Cromwell

Moved On
ECF Veteran
Feb 16, 2015
14,009
65,472
elsewhere
Most likely just smolder the cotton. The air/fuel ratio would be wrong for ignition.

If you took the cap off while the coil was still glowing it would just flame up.
Good point I still remember the vid of the oriential professional vaper dude with the 300 watt or so mod :)
 

LJFinFLA

Vaping Master
ECF Veteran
Jul 9, 2014
3,667
25,604
SW Florida
Yeah, try that, one drop at a time (don't know what your dilution rate is). Better to start low and add more if you think it needs it. One thing I found is that it's much stronger the longer it ages. I have a bottle of frost dragon (dragonfruit/strawberry/koolada) that was perfect a couple months ago, but when I got into it the other day, the menthol was overpowering. So it's kind of a touchy one. Use up what you make quickly, or put in a very low amount and let it sit around for a while and THEN check it. I don't use it in a whole lot of things, but I love the coolness of it, so the juice I do use it in usually doesn't last long. I simply "forgot" about that bottle of frost dragon for a while. :oops: It's still not garbage, though, because mixed half and half with another fruity type juice, it's still very good! :)

I tend to add it in the tank only. Never in my mix.
 

Lannie

Ultra Member
ECF Veteran
Verified Member
Jun 6, 2015
2,319
21,683
68
The windy plains of South Dakota

I already told Rixy, but for everyone else's amusement, I labored over my coil jig until I produced the most beautiful pair of coils... came out to .45 ohms, just what I was aiming for. I wicked them, tucked the tapered tails neatly under so they're *just* touching each other under each coil, put a little juice in the tank (5 or 6 droppers full) from the BOTTOM, stuck the deck back in, screwed the base cap back on, and tried it out. Way too much air and not enough wattage. I turned the air down to only two holes open, tried that and it was better, but still needed more wattage, so I was changing the wattage up from 35 heading for 40, and it puked all over my hand and mod. Not just puked, PROJECTILE VOMITED!

So. I assume I did something wrong, but I'm not sure what it is. 4 of those 5 or 6 droppers of juice are all over ME now (well, I washed, but I still have some on my jeans, yes, it went far...). Any ideas what I might have done wrong? :unsure:

Right now it's sitting on its drip tip, hopefully unable to puke further until I figure out where I went wrong. o_O
 

Debadoo

ECF Guru
ECF Veteran
Verified Member
May 18, 2012
18,052
133,969
Texas, near Fort Hood
I still remember the vid of the oriential professional vaper dude with the 300 watt or so mod :)
150, yeah....that's enough for me <cough choke> ok...100 yeah that's enough for me... <gag wheeze> ok....60 yeah that's enough for me! :facepalm:

I tend to add it in the tank only. Never in my mix.
so is a drop in a 4ml tank too much?
 

Boden

Vaping Master
ECF Veteran
Sep 7, 2012
5,516
28,164
Lexington KY
I already told Rixy, but for everyone else's amusement, I labored over my coil jig until I produced the most beautiful pair of coils... came out to .45 ohms, just what I was aiming for. I wicked them, tucked the tapered tails neatly under so they're *just* touching each other under each coil, put a little juice in the tank (5 or 6 droppers full) from the BOTTOM, stuck the deck back in, screwed the base cap back on, and tried it out. Way too much air and not enough wattage. I turned the air down to only two holes open, tried that and it was better, but still needed more wattage, so I was changing the wattage up from 35 heading for 40, and it puked all over my hand and mod. Not just puked, PROJECTILE VOMITED!

So. I assume I did something wrong, but I'm not sure what it is. 4 of those 5 or 6 droppers of juice are all over ME now (well, I washed, but I still have some on my jeans, yes, it went far...). Any ideas what I might have done wrong? :unsure:

Right now it's sitting on its drip tip, hopefully unable to puke further until I figure out where I went wrong. o_O

My guess
Somehow the chimney got juice in it. Like heating a can of beans in a campfire the pressure under the liquid forced it out
 

Boden

Vaping Master
ECF Veteran
Sep 7, 2012
5,516
28,164
Lexington KY
I found something just a few minutes ago I've never seen before. In a patch of ordinary clover with flowers like this
image.jpeg


this clover flower caught my eye.
image.jpeg
 

Lannie

Ultra Member
ECF Veteran
Verified Member
Jun 6, 2015
2,319
21,683
68
The windy plains of South Dakota
so is a drop in a 4ml tank too much?

No, I don't think that would be too much. I didn't know what size tank you'd be using though, so like 1 drop in a 1.6ml tank might be too much.

that's known as the vaping baptism!! :lol:

Oh, boy! I be baptized? :banana: At least it wasn't baptism by fire! LOL!

My guess
Somehow the chimney got juice in it. Like heating a can of beans in a campfire the pressure under the liquid forced it out

I didn't accidentally get that much juice in the chimney. ;) In fact, I got none in there when I filled it. Or are you saying somehow juice got in the chimney after it was all put back together? How could that happen? :unsure:
 

Lannie

Ultra Member
ECF Veteran
Verified Member
Jun 6, 2015
2,319
21,683
68
The windy plains of South Dakota
Status
Not open for further replies.

Users who are viewing this thread