Now it's been dropped twice, the once on gravel, and today on concrete, out of my pocket "T" pocket, a good drop! Got a little scuff on it The top cap and DT went flying off, but the tank didn't move a bit! Cleaned the sand off the top cap, put it all back together and it was game on! I'm getting very impressed with this set up!
Still wish the tank was a bit bigger, had to fill it three times today, with the high ohm build I'm using.
Didn't get my wire yet, and still don't have enough juice on hand to comfortably try feeding the notch coil yet.
But if anyone wants to do MTL, seriously, change the drip tip to a longer one! Even then I find when I'm chain vaping hard, I get a mouthful of juice from the condensation.
Just like a typical Genny, it's a love/hate relationship. You have to pick your battles, just like in marriage! You want flavor, get one! You don't want to have to fiddle with the coils and keep them from shorting out on the SS mesh or wire rope? Get one!
If you want a huge cloud and do lung hits, get one!
BUT........
If you want a tank for an ADV, this isn't it.
If you are a true MTL vaper, this isn't for you. (I liken it a lot to the Kanger Dripbox, if you fiddle with it enough, it's workable, but it's never going to be right.)
If you don't want to carry a needle bottle, syringe, or have lots of patience to fill it, this is not for you.
It's great in a lot of ways, and leaves a lot of potential open for a lot of different things. I'm looking forward to having the time to do a dual vertical coil build on it, at a higher resistance. I also look forward to doing some SS builds on it.
Had I bought it and used it as is, I would not have been happy! But fiddling with it, changing the DT, you must use a larger O-ring, or pack the o-ring with dental floss, to get one to fit tight.
Flavor is on par, or better than a KFL, but it's harder to build IMO, and doesn't hold anywhere near the juice. Nor am I sure it will "travel" as well as a KFI.
