New vaporshark 20 owner here and have a question..
My ohm reader only reads .9ohms on everything..Currently running pt2 with stock 2.2 head and shows .9ohms when fired and released. Does not matter what I attach for atomizer. Anyone have similar issue?
Does my unit need a hard reset? Everything is soldered so I would have to disconnect ground and reattach?
Just trying to avoid sending it in.
It is my understanding that if you fully drain the battery fully to the point where it will no longer fire... the dna 20 board will do a reset and the Ω readings will return to normal... It's a dna 20 thing but does seem to happen a bit more often with the vaporshark than with say... a ProtoVapor XPV, perhaps this is just my perception and there may be more of the vaporsharks around so perhaps it isn't a fair assessment. But that should fix you up...