Attack of the (Kayfun v4) Clones!
- Thread starter KTMRider
- Start date
- th_trl_thread_readers 0
- Status
Ok, mine has all the correct o rings now. However, my resistance is jumping again, whether the spring is in or out. And now the base is wobbling and I don't know why.
I am getting some pretty darn good flavor so I want to get it 100% squared away.
Also wondering if anyone has the resistance issue with the Tobecco or EHPro?
I am getting some pretty darn good flavor so I want to get it 100% squared away.
Also wondering if anyone has the resistance issue with the Tobecco or EHPro?
The resistance fluctuates a little on my tobeco. 0.4-0.45ohm nothing to be enough to notice vaping it.
Well there is the ground side to be looking at, that's the threaded part of #17 where it screw to #8. Then where #8 butts to #3. Of coarse the coil screws are tight right?
Did you try turning your 510 screw out just a bit?
My Tobeco from Artemus made it to Houston! The original delivery date was Saturday, but I'm really hoping USPS can come through for me and get it to me tomorrow!
I can't wait to see what it'll look like with the IBT glass tank on it.
I can't wait to see what it'll look like with the IBT glass tank on it.
Unscrew the entire RTA to the left while holding just the base still. Once it stops turning you can unscrew the top piece that the 510 drip tip sits in and fill it from the top. Then, after screwing the top piece back on, screw the entire RTA while holding just the base still to open up the juice channels.
Alright guys just finished setting up the infinite clone ....even though I cleaned it didn't get a machine oil smell from it ( my first szeaster clone stank of machine oil ) everything is pretty much spot on ...threads are nice ( don't know what kind of stainless steel they are using ) comes with a bag of orings and screws ( no extra spring ) all the tank parts plus a bell cap! Haven't used it yet using glass right now . the juice control is nice and not overly to hard to turn ..its reading on my DNA 40 the right ohms ( my szeaster was reading .01 higher prob spring related ...no leaking so far but only a hour or so of vaping ...don't have a tobeco version so can't compare to that one but have to say I'm very happy with infinite clone right now ....hope that helps
my infinite clone came with bell cap and a small rubber plug I'm assuming I plug drip tip with it while filling? And thank youfrom bottom like this picture
I'm trying to decide about cleaning and keeping this kayfun v4 I got from code vape today.
Does anybody know how the kayfun v4s with red o-rings are? I don't know how many different ones come with the red o-rings or who made this one, code vape claims a-mod, but I don't think so.
It came with the glass tank installed, and has what looked to be brass colored springs if that helps.
I already have it packaged back up for return, but the vendor hasn't gotten back to me yet with a RMA, or return instructions.
Sent from my Nexus 6 using Tapatalk
Does anybody know how the kayfun v4s with red o-rings are? I don't know how many different ones come with the red o-rings or who made this one, code vape claims a-mod, but I don't think so.
It came with the glass tank installed, and has what looked to be brass colored springs if that helps.
I already have it packaged back up for return, but the vendor hasn't gotten back to me yet with a RMA, or return instructions.
Sent from my Nexus 6 using Tapatalk
Sounds like the same one I got off ebay. No clue of manufacturer on it. Only problem I've had so far is a small amount of leaking through the vent holes
- Status
