yup, the nic hits hard on this build too, I think it's the way it atomizes it inside the coil
You're absolutely right iTEO. The nic is crazy even at 6 mg ! LOL!!!
yup, the nic hits hard on this build too, I think it's the way it atomizes it inside the coil
You're absolutely right iTEO. The nic is crazy even at 6 mg ! LOL!!!
For a one venting coil, about half of the coil (one side) is in the cotton wick. For a dual venting "dragon" about half of the entire coil is in the wick but make sure it's not too buried into the cotton wick, both ends must have an opening.
here's my single venting coil build...
By the look of the pic, the other side of the coil is blocked. It will spew out vapor if both ends are open. Hope this helps.Kinda having trouble wicking the dragon. I mean I kind of got it, but I know it could be way better. The way I'm doing it is I kind of make a C with the cotton. Bottom of the C is under the coil and the top is over. Tips?
Hmm can't get the wicking right for some reason. It vents but it's not much. Teo or Jimi, how did you guys wick? And how many wraps because I'm doing 8 lol.
Hmm can't get the wicking right for some reason. It vents but it's not much. Teo or Jimi, how did you guys wick? And how many wraps because I'm doing 8 lol.
I used a 7 wrap of 28 AWG A1 dual coil on a bed of Q-Tip cotton, just pulled it off the swab stick with a dental pick. Working great, just leave the higher end of the coils exposed & you will be golden!
edit: how big are your air holes on your atty? On my Patriot they are 5/32 & on my Nimbus they are 1/16. You need good airflow for this setup.
Good job guys! it's a very easy build and very efficient... it's really science at it's best. You don't even have to take hard long exhales to produce massive vapor.
Those bottom feeders are going to be cloud monsters now
I don't see why notI'm wondering if this build can be adapted to work on a terminator c, I think I'll try and see what happens