Vapor Shark dna 75!!! my prayers have been answered! and it doesn't look any taller than the rDNA 
Vapor Shark® DNA75 - What's New!
Vapor Shark® DNA75 - What's New!
Evolv DNA 75
- Thread starter Chris5135
- Start date
- th_trl_thread_readers 0
- Status
So Vapor Shark has two new 75s or is this just a pre-production picture of the much different SwitchBox?
Interesting, that looks like my VS DNA200 box, says out of stock. I preordered the switchbox version, but looking at their site just now, the switchbox link only shows the replaceable covers. Odd.
It's still there. The link was in the wholesale section and the Switchbox isn't there.
SwitchBox DNA 75 (Pre-Order)
SwitchBox DNA 75 (Pre-Order)
My guess is that picture in the wholesale section might have been from before they finalized the design?
They also have the same picture listed as a rDNA60. I'm trying to figure out what's going on.
Vapor Shark® rDNA60 - What's New!
Last edited:
anyone care to take a guess as to what those 3 holes (or whatever) are at the bottom of the VS dna 75's USB port?
Having a problem with me sdna 75, would like some input if possible. Okay problem happens on several rta's running twisted 316l ss wire if that makes a difference. But I will set the mod in this case, in power mode for 17.5w, hit fire and I can see the wattage climb to over 50+, burns the crap outa my mouth, and then flashes 'ohms too high'. I have no clue what is going wrong. Usually i can pull the battery out, and re-insert it and that will solve the problem, but not recently. I haven't hooked up escribe yet, but that's my next step when I get a moment. Right now I'm using a single .47-.49ohm twisted 316l ss wire in a merlin and serpent mini rta. Both work fine on my dna 200 and other mods.
Any thoughts or suggestions?
Thanks
Any thoughts or suggestions?
Thanks
I'm not sure, but it sounds like a hardware/firmware failure to me. No matter what your build, it shouldn't fire above what it is set at. I'd be contacting Evolv.
Well I believe I have figured out out. Turned out kanthal\wattage mode was sensing a temperature controlled wire type. It was boosting for the first second in think, so I turned it off in escribe, seems to be working good so far. Thanks all
I don't know, it seems like if it was in wattage mode, it should stay in that mode. Particularly if it's SS which can be used TC or wattage.
Actually I didn't read the post well enough, I missed the part about using SS, I thought is was Kanthal.....duh
When Daniel set up the SDNA75, he supposedly purposely used a modified kanthal TC curve equivalent Profile & Called it Power Mode to allow the use of pre-heat on a non-TC build.
Forgot about that because I use SS Exclusively in TC mode & almost never use Power Mode anymore (hard to imagine even wanting to). If I wanted to use SS in power mode I would still use the SS material & turn off TC mode by raising the temp above 600, but that's just me.
The thought never even occurred to me that wrong TC Curve could be causing excessive Pre-heat! Sorry & glad he/you got it sorted!
Last edited:
OK, that makes sense. It's good to hear the board didn't go south.
- Status
