That's right, really very small.
it is not a problem for me but i just wonder. And also it is a good thing that it is not necessary to disassemble all parts for every time.
Thank you imeo. Armed is the best until you improve new one.
If you really want to cut down on the residual vapor that escapes through the AD control ring holes, extend your vape slightly past when your release the firing button. That will allow you to get most of the vapor it produced when firing. In addition, watch your
juice control; if you have enough leaking around the AD ring and especially out the holes - it's probably a little flooded. Close the
juice control completely off, remove the Armed from the mod, remove the AD ring and grab a tissue or paper towel. Making sure you have the
juice control tightened all the way down, blow through the chimney while holding the bottom in the tissue. If you only get a little bit, it's just vapor buildup; if you get a LOT - the chimney area is flooded and running down the air hole to the bottom of the Armed.
I hope this helps! These are just observations i've noticed and learned from with my Tilemahos Armed atomizers.
-Mark