GP Series by VapourArt - Official Thread for GP Spheroid, GP PAPS, X, GP Piccolo, GP SnP and more - Part 3
- Thread starter perseas
- Start date
- th_trl_thread_readers 0
- Status
Yeah. Rumor has it this guy was seen in Idaho.
Again. I'd need to verify the facts. I hate rumors.
Last edited:
You know how those rumors go...
I heard, it was a woman in Florida. I wouldn't quote me on that. Just a rumor.....
Need some help....imagine that as y'all pros know I am still learning!! I cleaned my spheroids and had troubles with one of them. After cleaning and reassembling the base, the "piece" with the 3 holes that goes through the bottom into an insulator is not snug anymore so I'm not getting a good connection when I put the spheroid on a mod. The "pin" pushes back up from the bottom and I have takenit apart several times and pushed down on the top as hard as I can push but it still easily pushes back up from the bottom!! Do I "tap" it with something heavier than my finger or do I have a problem with the what I call grommet or insulator in which it seats in?
Tonite is one of those nights I wish I had one of you pros cell number because I probably won't sleep tonite until I get it fixed or even worse having to wait for a part, dang it all!! Please advise!
Edit: posting in the Spheroid thread as well to be sure I hopefully get some solutions.
Sent from my iPad using Tapatalk
Tonite is one of those nights I wish I had one of you pros cell number because I probably won't sleep tonite until I get it fixed or even worse having to wait for a part, dang it all!! Please advise!
Edit: posting in the Spheroid thread as well to be sure I hopefully get some solutions.
Sent from my iPad using Tapatalk
Last edited:
What's up GPeeps!! Guess everyone went to bed early tonight...
Idabro, I would like to donate to the FATRPWOCBCO.
Idabro, I would like to donate to the FATRPWOCBCO.
A small number of them is scheduled to be produced, no worries.
What's up GPeeps!! Guess everyone went to bed early tonight...
Idabro, I would like to donate to the FATRPWOCBCO.
Hello to both of you
I will be back a few hours later, it's morning here
Good morning
I forgot to mention that the winners of the Secret Santa Contest will receive 2 X rings, a brushed and a polished one.
I forgot to mention that the winners of the Secret Santa Contest will receive 2 X rings, a brushed and a polished one.
Bored? How about dual 650's?
I'm sure someone else has the right parts to pull it off and make it look good
OPEN YOUR MIIIINNNNDDDD
Sorry, just finished watching it and can't stop saying this to random things around the house.....
Sent from my iPad using Tapatal
OPEN YOUR MIIIINNNNDDDD
Sorry, just finished watching it and can't stop saying this to random things around the house.....
Sent from my iPad using Tapatal
Ok. This doesn't go well with coffee. Just sayin'.
Am I correct in thinking that the **only** way to get the phillips screws for the spheroid base is to replace the whole base? Or is there a ver 2 -> ver 3 upgrade kit? $73 USD to replace the base seems a big bite when I paid $110 USD for the whole thing? Hopefully I'm asking this right?
So to clarify further, what I would like to do is replace the thumb nuts with screws on my Spheroid are parts available to do this for reasonable cost?
Last edited:
- Status
Similar threads
- Locked
- Sticky
