- Status
Or you could start by trying to see if it'll short out when only the bottom cylindrical section is on. That'll be a easy and fast test.
Ah Welp. It's the screws then. Hopefully you have some smaller diameter head screws around.
Also make sure you dont have a stray wire or too big a coil...
I'd say a loose coil tail touching the chimney section (or the coil being propped up too high and touching the chimney) is the most likely cause. Kiiwi could be right too.
It was the screws, thanks again for the help everyone!!! Another reason this forum is the best around.
My tobeco clone arrived today and my first vape from it (after about an hour of trying to convince the screws to hold the coil) with Thug Juice was intense. The coil isn't pretty but at least I got it working. 32 gauge with cotton at 1.4 ohmes. I don't have a torch, and I couldn't convince the 32 gauge to get snug enough to make a microcoil so it's just a regular one, but I have 28g in the mail so hopefully I'll have better luck with that.
I have a question, though. I'm using this chart for reference that says anything over 8.5~ watts would fry juices at 1.4 ohmes, but I see a lot of people mentioning using much higher power at the same resistance. Is this something that is different when using rebuildables vs. cartos? I'm using a MVP 2.
I have a question, though. I'm using this chart for reference that says anything over 8.5~ watts would fry juices at 1.4 ohmes, but I see a lot of people mentioning using much higher power at the same resistance. Is this something that is different when using rebuildables vs. cartos? I'm using a MVP 2.
In general I find that I burn juices at the wattages people report on here, I chaulk it up to not being able to make a class A build.
Can someone confirm these work with the ehpro:
Vaperev Shop - Kayfun Spare O-ring and Replacement Screw Set
If remember someone with a blog but can't remember the name, if anyone has any leads it would be appreciated
Last edited:
The nano kit with the m-tank fits onbthe ehpro v2 but the one with the drop stainless tank doesn't - I get the mtank version off eBay. For the hcigar v2 youll wanna use the nano kit it comes with. The top cap was redesigned on the v2 and the pitch of the nano chimney won't let you screw the top down but the mtank version of the nano gives it enough room for some reason
Ok, I guess what I'm really trying to ask is, which Kayfun clones fit the stainless nano kit from Fasttech? I have my Hcigar v2 in it's nano form with the flat top cap and I have a Tobeco clone which I'm not sure which version it is, but it looks like the standard Kayfun and has the air adjustment on the bottom, that fit a nano kit I bought off eBay (it's the SS one), which I assume is the same one as Fasttech's version. The Hcigar nano kit is not the same, it's ss rings are bigger and the whole unit is larger looking than the regular nano.
An option would be to:
1) read as many reviews and discussion of the sku as possible
2) post a question on the SKU's discussion page. You're better off doing that and getting a proper answer instead of speculatiobs
1) read as many reviews and discussion of the sku as possible
2) post a question on the SKU's discussion page. You're better off doing that and getting a proper answer instead of speculatiobs
- Status
Similar threads
