Orion V2 roll call
- Thread starter tierrataz
- Start date
- th_trl_thread_readers 0
- Status
As long as you buy/use bigger orings it will not be a problem, the owner is suspose to be sending me a tank and orings to test out on my orion for a future CO-OP for his pyrex tanks
Nice. I shall wait for your test first
. Actually i dont own an orion now. Waiting to be shipped from the UK. The owner dropped his pyrex and left me the poly tank T.T. On the brightside, i got the orion below rrp .
Guys, I have a big problem. My wife accidentally knocked my Orion 2.1 off the table two days ago, and I was so relieved that the tank didn't break, I didn't notice that it was shorting until I smelled it cooking. I tore the battery out, and once it cooled a bit I took off the cap. My spring is toast, my center post is tarnished, my washer and nut are really tarnished and brittle. I tore her down and removed my destroyed wick and coil, took off the tank, and gave here a good cleaning. Today I put a battery in it, and tested the switch using a multimeter. My switch is toast too, always on.
I really want to get this baby firing again, and I know that pailpoe sells replacement switches on vaporwall, but after registering two weeks ago, I still havent been approved. If anyone has a switch I could buy, I'd really appreciate it. Or if anyone could get me approved at vaporwall...
Also, I'll need a replacement spring, so I was gonna steal one from a ballpoint pen...will this work?
Thanks for the help guys, I sure appreciate it.
Regards,
Dredd
I really want to get this baby firing again, and I know that pailpoe sells replacement switches on vaporwall, but after registering two weeks ago, I still havent been approved. If anyone has a switch I could buy, I'd really appreciate it. Or if anyone could get me approved at vaporwall...
Also, I'll need a replacement spring, so I was gonna steal one from a ballpoint pen...will this work?
Thanks for the help guys, I sure appreciate it.
Regards,
Dredd
Nice vid. Was that done with the stock air hole? I'm still playing around with my coil setup, and wick dimension trying to find my sweet spot for this device.
I did forget to mention in the vid that it is 100% stock no mods to the orion
Man that sucks,
Sorry,
as for vaporwall I had been waiting for days then I sent a email to the admin from the main page when you try to see the forum.
he approved me the next day or later that day (can't remember for sure)
Any chance you could PM me the email address? I can't seem to find it.
You got the email from delboy when you registered? Same email addy used when it gets approved. Took 9 days for mine.
Just order one from pailpoe or del. I have one, but it is my spare, in case, I need a spare.
Sent from my Samsung S III running on SS mesh and kanthal.
Give it a day ot so. The samething happened to me
Sent from my SAMSUNG-SGH-I747 using Tapatalk 2
Sent from my SAMSUNG-SGH-I747 using Tapatalk 2
I will pm you Pailpoe's PP, send him 15 euro's and make sure your addy is in your pp
Thanks so much emonty!
Now, any words of wisdom on finding a spring? Do ballpoint pen springs work?
Now, any words of wisdom on finding a spring? Do ballpoint pen springs work?
I sent the payment and info as suggested, sure hope I didn't need to email/pm him first! With any luck, I'll be firing on my Orion by Christmas!
- Status
Similar threads
