So I murdered my only Penelope ceramic today
Is there something I'm doing wrong on assembly that makes the ceramic section so impossible to separate from the base? I've read through and know not to tighten it too much and haven't been. I had to use 2 sets of pliers and the ceramic cracked long before I got the pieces separated.. I'm rather frustrated with it. Never had this Happen with Ody on either base. Is the oring too big under the cup?
Now my poor Penelope is out of service lol. Sorry about the vent lol, I was hoping to use it away this weekend.
Hi Chinner.
As kwalka said, use some vaseline on the botton o-ring, or you can replace that o-ring with an smaller one, try with an AS568 004 o-ring (5/64 Inner diameter, 13/64 Outer diameter, 1/16 cross section or 0.070"ID x 0.070" CS).
If I remind fine, the O-Ring that originally came with the first Penelopes was slightly a bigger one.
