Daniel Forsyth

Vaping Master
Supporting Member
ECF Veteran
  • Mar 26, 2019
    9,404
    56,881
    45
    Victoria, Australia
    :thumb:
    image.jpg
     

    gloopdegurp

    DIY Hack
    ECF Veteran
    Feb 3, 2022
    2,717
    12,256
    58
    Pennsylvania, USA
    I tried my first vertical build today in one of my Serpents and it's working pretty well so far. Flavor is intense!
    I'm only at about 40 puffs so far with it so it remains to be seen if it will hold up. I haven't pushed it very hard, but I usually vape my setups at the lower end of their power ranges.
    Legs and wicking are a bit wonky, but it works!

    20230131_152045-COLLAGE.jpg


    IMG_20230131_153348014~2.jpg
     

    ShowMeTwice

    Supporting Member
    ECF Veteran
    Jun 28, 2016
    18,900
    1
    125,620
    the Universe • ∞
    I tried my first vertical build today in one of my Serpents and it's working pretty well so far. Flavor is intense!
    I'm only at about 40 puffs so far with it so it remains to be seen if it will hold up. I haven't pushed it very hard, but I usually vape my setups at the lower end of their power ranges.
    Legs and wicking are a bit wonky, but it works!

    Very nice vertical build!!! :toast:
     

    gloopdegurp

    DIY Hack
    ECF Veteran
    Feb 3, 2022
    2,717
    12,256
    58
    Pennsylvania, USA
    Very nice vertical build!!! :toast:
    Thank you, SMT!
    It was a little challenging (for me!) as the OG Serpent's posts are a bit cockeyed compared to most decks and the juice wells are completely open.
    That big round center airflow in the deck looked tailor-made for it though!
     

    gloopdegurp

    DIY Hack
    ECF Veteran
    Feb 3, 2022
    2,717
    12,256
    58
    Pennsylvania, USA
    Second vertical build, haha!
    This time in Serpent #2 with 26g N80, the first was in Serpent #3 using 24g N80.

    20230131_234656-COLLAGE.jpg IMG_20230201_000225441.jpg

    I did need to adjust the wicking from my first try as hits started getting a touch dry around 70 puffs.
    I had to tighten the wicks up some and did a little trimming.
     

    Users who are viewing this thread