ProChat - All Things ProVape and Beyond

Status
Not open for further replies.

rbrylawski

Sir Rod - MOL
ECF Veteran
Verified Member
Jul 11, 2014
8,211
34,162
Tampa, FL
i did it, then when i set my provari down, my daughter bumped my arm and it hit the floor... concrete floor. I almost died. but it all looks fine!

The perfect, consistent vape aside, this is why we all vape Provari. Most lesser mods won't work anymore when they fall on a hard surface, but a Provari just laughs and dares you to do it again!
 

JUMA55

Ultra Member
ECF Veteran
Verified Member
Jul 4, 2014
1,031
6,104
Waco, TX
The Truth, Mr. Juma speaks.

Power corrupts.

Of course I do have to thank the police for one thing: vaping. A couple of years ago one of the local police chiefs announce he was going to make it illegal everywhere! I figured if this clown was against it, I'd probably like it. Tried it. Did like it. And here I am.
 

Bronze

ECF Guru
ECF Veteran
Verified Member
Aug 19, 2012
40,240
188,000
  • Like
Reactions: gnees

rbrylawski

Sir Rod - MOL
ECF Veteran
Verified Member
Jul 11, 2014
8,211
34,162
Tampa, FL
I will learn :) i just got the P3 yesterday skimmed the book of instructions and got to vaping lol.
kabuki is 1.9 ohms right now i'm at 4.1 volts.

The two Nautilus coils most use in the Kabuki come in 1.6 ohm or 1.8 ohm. I believe the coil that comes preinstalled is 1.6 ohm.
 

Pinggolfer

Vaping Master
ECF Veteran
Verified Member
Jul 28, 2013
6,891
18,798
The Clemson Tigers State
So you are using Activation Lock?

I have a LG G4 and have lockout. To open my phone i use a certain swipe. I tried the digit code and hated it. PITA to put phone down for a minute and have to put code back in.

If I was shot and I had taken a picture of the shooter the FBI could do what they want with my phone.
 

Ladiekali

Vaping Master
ECF Veteran
Verified Member
Sep 1, 2013
5,636
9,227
Florida
The two Nautilus coils most use in the Kabuki come in 1.6 ohm or 1.8 ohm. I believe the coil that comes preinstalled is 1.6 ohm.
well it's totally reading 1.9 ohms... i did get the p3 version from provape. so i'm not sure if it matters where you purchase it from? maybe?
 

rbrylawski

Sir Rod - MOL
ECF Veteran
Verified Member
Jul 11, 2014
8,211
34,162
Tampa, FL
well it's totally reading 1.9 ohms... i did get the p3 version from provape. so i'm not sure if it matters where you purchase it from? maybe?

That's OK. Your P3 is a bit more accurate than the marking on the coil. It means your Kabuki came pre-packaged with a 1.8 ohm coil.
 

Ladiekali

Vaping Master
ECF Veteran
Verified Member
Sep 1, 2013
5,636
9,227
Florida

Bronze

ECF Guru
ECF Veteran
Verified Member
Aug 19, 2012
40,240
188,000
ok i found it. just have to wait a few seconds and it switches to wattage :) i got it at 9watts for now.
Good Girl! Now use the watts as your deciding factor. 9 watts is normal. Try it from 8 - 12 and see what you like the most.
 
Status
Not open for further replies.

Users who are viewing this thread