Status
Not open for further replies.

SummerDawn

Vaping Master
ECF Veteran
Verified Member
Aug 11, 2011
4,871
8,778
36
Wyoming
Thank you for the kind words, pchela.

And thanks, Air. The only place where the crack is really noticeable is on the side under the firing button where it actually broke into the endcap. The rest of the crack is right along the line between the panel and the endcap... Not noticeable at all. I'm gonna go ahead and glue it and put the buffing off for awhile until I'm sure I'll do it right. Thanks again for your help.
 

Capt' Brian

Unregistered Supplier
ECF Veteran
Bumping, think you might have missed the post

Summer, you could use superglue and clamp it for a couple hours as mentioned before, but could you post a picture of the break? Also, I know you just got it, but if you send it back to me, I would bet dollars to donuts that I can fix it so you can't even hardly tell where the crack used to be :)
 

SummerDawn

Vaping Master
ECF Veteran
Verified Member
Aug 11, 2011
4,871
8,778
36
Wyoming
Dang. I just superglued it before I saw Cappy's post and it is currently setting. It's now a bit difficult to see the crack, but as I said Cappy... On the wider sides it is almost a completely clean break along the line between the endcap and panel. However on the side beneath the firing button, it cut down a bit into the endcap. Not far, maybe an eighth of an inch.
 
Status
Not open for further replies.

Users who are viewing this thread