Hi partners! I am starting to receive the hardware you sent me. I can tell you right now at least two of the "dead" atty's are ok. It's going to take me some time to get my program ready but I am very excited to have the hardware and will begin setting up the test this weekend....I was supposed to be on a contract job this week but some hurricane in the Bermuda cancelled the job until next week, starting on Tuesday, so I'm gonna be busy for a week but no fear, I'll get this done ASAP when I return.....I've already learned a few things just by examination of the hardware....I still have plenty of room for anybody that wants to send me some dead atty's for the test cleaning. The point of this test is to finalize a cleaning and refreshener solution that can be used to extend the life of 801/112 atty's. Anybody that contributes to the test will receive some of the final solution for your use...here's some tips that I have determined are true....
vodka acts as cleaner and a slight amount mixed with your juice will act as a cleaner everytime you vape
low batt power will gunk up the atty due to incomplete burn of fuel. If you are having batt problem, the lack of power is gonna kill your atty faster...
hydrogen peroxide has attacked the solder in more than one atty, don't use it anymore
Isopropyl Alcohol, unless it says "for internal use" on the label, don't use it or use only small amounts...( better to not use it)
if your cleaning your atty's and NOT seeing small chunks/flakes of carbon in your cleaning fluid, your probably not getting to the real problem. If your fluid gets darker duirng the clean cycle, you might be doing some good but mostly your only taking the varnish and soot off the atty tube, boil bowl, and mesh....
If you make your own juice, that could be part of the problem. The wrong amounts of the right ingredients can be an atty killer...
Thanks again to everybody, for giving me the tools/supplies I needed to serve the E-cig community! (I NEED MORE GUNKED UP ATTY'S for the test)
vodka acts as cleaner and a slight amount mixed with your juice will act as a cleaner everytime you vape
low batt power will gunk up the atty due to incomplete burn of fuel. If you are having batt problem, the lack of power is gonna kill your atty faster...
hydrogen peroxide has attacked the solder in more than one atty, don't use it anymore
Isopropyl Alcohol, unless it says "for internal use" on the label, don't use it or use only small amounts...( better to not use it)
if your cleaning your atty's and NOT seeing small chunks/flakes of carbon in your cleaning fluid, your probably not getting to the real problem. If your fluid gets darker duirng the clean cycle, you might be doing some good but mostly your only taking the varnish and soot off the atty tube, boil bowl, and mesh....
If you make your own juice, that could be part of the problem. The wrong amounts of the right ingredients can be an atty killer...
Thanks again to everybody, for giving me the tools/supplies I needed to serve the E-cig community! (I NEED MORE GUNKED UP ATTY'S for the test)