Thats a good question roxy. Its from a bag of spares i had with an old taifun. I probably should have measured it cause I'm gonna need at least one more when my replacement serpent gets here from eciggity. I'll pull it out next time i rebuild and make a trip to ace hardware to find the numbers. I'll post when I get it. I don't have a caliper to measure it.
Check further back in the thread. Someone has already come up with a reducer for the airflow hole.
I haven't troubleshot it much, but I am also getting poor performance out of the SS316 coil and temp limiting on the mods I've tried, dna200, sx mini, and rx200. For me I think its wicking, not getting enough juice flow.
The weird thing is that ss304 works in all my other atties, and I get the same pulsing-temp protect behaviour with only the deck and fully saturated deck. And, as I said, the ss304 coil works perfectly in vw mode at 40w. I'm quite sure that my leads are tight. I'll have to tear down the Serpent tomorrow and see if I can find where the problem lies.
I think I solved it for me, tightened down the 510 screw. Vaping on the RX200 at 30W and 450F, it doesn't even hit temp protection now at that wattage.
Didn't do anything for me. The DNA 200 atomizer analyzer shows the atty as stable. I've tried both titanium and ss304 coils with the same result. A ss304 coil that his tc at 8-10w works well at the 35w, so clearly the temp is read wrong in some way. Something loose, but it's not the coil in the posts. Anyone here use escribe? I'm wondering how I could use it to troubleshoot the atty.
