SvoёMesto KAYFUN 4
- Thread starter qorax
- Start date
- th_trl_thread_readers 0
- Status
Ooooh... where did you find that ugly sticker? Is it the cheaper clone from focalecig or just a bad pic?
It should more look like this:
Surely you realize that is a clone, please say you knew..........
Maybe not, could be a bad angle. Maybe...
Sent with no malice and not a whole lot of forethought from my new Galaxy Tab 4. Thanks Santa!
I got the K4. The juice control threading feels kind of rough. Hopefully it smoothes out. Also, the instructions say the unit is free from any oil residue and to only rinse juice contact parts with warm water. I noticed what looks like lubricant on the juice control threads. Should that be there?
Also, the bottom most assembly doesn't seem to come apart. It just spins freely and doesn't seem to disassemble. Also, I got no spare o-rings or anything else with the unit. I did get the tanks though.
Also, the bottom most assembly doesn't seem to come apart. It just spins freely and doesn't seem to disassemble. Also, I got no spare o-rings or anything else with the unit. I did get the tanks though.
Last edited:
Make sure that you clean it well! SvoeMesto says that their good to go, but myself and many others have had to do a thorough cleaning prior to use. The bottom air-intake ring is connected to the base, as far as I know.
I will clean it all. I'm just afraid the juice control threads will bind if they are clean and dry.
Try to get a picture that shows the "hologramy-ness" of the sticker...if it's a hologram sticker at all! Authentic should be!
If it's authentic, the good machining won't let it bind up.
Just don't tighten anything in either direction...
And don't stress! Remember we are all here to help you!
Just put a little juice on them and that should work. I just cleaned mine twice and put it together. I noticed that my juice control became smoother the more that I used it and now it operates perfect.
I thought the same thing, so I took pictures of mine from all angles and I couldn't replicate what the picture in question looks like. All my pictures showed the hologram clearly, with and without the flash.
I didn't remove ALL of the o-rings, just the one on the chimney. I trust there isn't some toxic gunk hiding under all of them. I washed with dish soap and rinsed. Now drying and reassembling with P3 connecter. Wish me luck.
You did a better job than me. I didn't remove any of the O-rings. I guess that I didn't clean it as good as I thought!
......and Good Luck
no more like this...
better here:
So SMtec GmbH sent me a clone directly from Everswinkel?? If so, that's a nice one
R
Was there an issue with the P3 connector not sitting flush all the way? Because mine won't.
Moon, I don't know what causes it as I have not had the issue. At least one other member has, but it was corrected with a reassembly. Sorry I can't explain it, but know it has happened and can be fixed.
- Status
Similar threads
- Locked
