The BF experiment
- Thread starter EagleTa2
- Start date
- th_trl_thread_readers 0
- Status
Where did you buy yours from? I bought mine off Ebay and it is the same lettering as the authentic Grand Vapor V2. The ones with the backwards E are Tobeco and EhPro from what I have seen and have the same lettering as the V1...
It has been posted in this thread a few times. I used a #60 to drill the insulator on my Atomic. I drilled 2 holes in it and it feeds 70-80% VG very well. I haven't tried 100% VG, but have no doubt it would work great...
Last edited:
I would guess it's a Ehpro I got it from a B&M. I think they do business with them. My Caravela was from Ehpro too don't see why it would be any different.
From the pics I have seen of them they are very well built. I purchased the Infinite because I liked the V2 lettering that Grand vapor used... The V1 lettering is ok, but the V2 just struck my liking more... Hope your modding goes good for you. I am really enjoying mine. I just can't seem to put any of my other atty's on the grand at all. I really need another LP grand!!!
Yeah it's gonna be hard to pull off the Patriot that FB modded and sold to me.
ETA it was in the classies.
ETA it was in the classies.
Just saw a Zenith V2 Clone pop up on Fasttech. Looks from the photos like it's a candidate to drill the insulator with pin in place. Must...resist...oh who am I kidding.
Hey guys...would the Origin v2 clone work with the new BF center post?
Bottom Feeder Kit for Origen Dripper V2
Bottom Feeder Kit for Origen Dripper V2
Another tip that worked for me especially for BF modders:
On occasion, we botch up the modification- I just did on my first try with a Patriot clone I am using until my RM2 gets here. The hole is off line, we mis-drill, end up getting one of those "ugly" modifications. It still works, (my Patriot did), but I was getting leakage around the bottom perimeter of the atty. Get an o-ring and place it around the 510 connector. Replace the atty, snugly but not tight. The leaking stops, and now my cheap Patriot is working great!
On occasion, we botch up the modification- I just did on my first try with a Patriot clone I am using until my RM2 gets here. The hole is off line, we mis-drill, end up getting one of those "ugly" modifications. It still works, (my Patriot did), but I was getting leakage around the bottom perimeter of the atty. Get an o-ring and place it around the 510 connector. Replace the atty, snugly but not tight. The leaking stops, and now my cheap Patriot is working great!
Last edited:
Should have tried slotting the sides of this one too. Stripped threading on positive post a bit. Still works good.
1.8 ohms on Stillare:
1.8 ohms on Stillare:
Nice job! I keep telling myself I will NOT buy a drill press just to mod rda's for my Reo's
Nice job! I keep telling myself I will NOT buy a drill press just to mod rda's for my Reo's
Harbor Freight has reasonable prices on a drill press
Harbor Freight has reasonable prices on a drill press
I know. Was in there last weekend for something else and talked myself out of it. There was no price on the shelf, a big line, and no one to help me, so I ran as fast as possible
. I have two Reos and about 10 rda's, so I really do not need. Figured it was almost as much as another Reo, and once I started that internal conversation, the drill press was much less attractive.
- Status
Similar threads
- Locked
