My was waiting for my when I got home from work. I've got to say this is exactly what I've been looking for. It flat out rocks!
It really is a beautiful thing
My was waiting for my when I got home from work. I've got to say this is exactly what I've been looking for. It flat out rocks!
Hi MSs, welcome to the LOD (Land Of Darwinia). Nice doghouse, there...
Panky: !!!
Capt: After the first few days, I made sure to get some low-nic juice, because I liked Darwin so much. You know, for safety's sake.

Hi MSs, welcome to the LOD (Land Of Darwinia). Nice doghouse, there...
Panky: !!!
Capt: After the first few days, I made sure to get some low-nic juice, because I liked Darwin so much. You know, for safety's
sake.
I have the only one so far that seems like it came without one attached. kinda sucks.

I like the option to be able to remove it![]()
problem is that I did not get one at all. Even if It had been in there, that would have been fine.
Right where the atty/carto screws in, there are four tiny slots, in the top of the plastic collar. i have read of some using a Dremel, but that seems like it would be too sloppy with me using it. Remove the bottle/needle, dry it out as good as you can, and use the hacksaw, and gently pull it through there. I didn't cut even a 1/16" of an inch. Be sure to blow out/clean the little plastic chips you have generated.
There is a little inverted funnel up in there, to help guide the needle in. I insert it carefully, rotating it back and forth to help it find it's way. I also put a piece of Scotch tape down the side, leaving a little tail at the bottom. It helps to pull the bottle out. On a review/discussion thread about the Boge Rev 2.1 someone posted a link for a replacement needle/bottle assembly.
problem is that I did not get one at all. Even if It had been in there, that would have been fine.
Sorry for not replying sooner....I havent recieved any emails talking about this....I will check later when the guys get in.
However , we didnt send any out without the adapters on the past two shipments...It's the silver piece that is screwed into the brass arm. It wont come off without pliers or some tool. Its only a quater inch or so long.
If your sure it isnt on there , send us an email to DGliem00@gmail.com and I wil take care of it. Thanks
Drew