The "WeekEnder"
- Thread starter mikepetro
- Start date
- th_trl_thread_readers 0
- Status
I bought the Tobeco version from 101 vape before they were given a cease and desist from the designer. It looks the same as the FT version, slightly different knurling on the outside, and the Tobeco's chimney matches the deck.
It hasn't been an issue for me, but I have noticed that leaving it on its side when ~1/2 full is a bad idea.Looked at it but those inlet channels look like direct drainage ditches to the air hole..I will let you test it first...
I'd give it a try, but I am just a little happier with the Taifun. The glass tank on the SQuape is nice, but not many folks around these parts vape tank crackers...
@bapgood: I'm liking the "Maxi", very nice.
BTW, I think we all have the same 1amp chargers, mine look the same.Hey bap, your logo is a real hit on there, it deserves second mention. The b goes up, the p down and the a swirls in the middle. Top notch!
Sent from my Nexus 4 using Tapatalk
Sent from my Nexus 4 using Tapatalk
Thanks asdaq!!!
I probably went thru a good couple hundred fonts to find one that I liked.
Todays laugh:
A man and a woman were having a quiet, romantic dinner in a fine restaurant. They were gazing lovingly at each other and holding hands. The waitress, taking another order at a table a few steps away, suddenly noticed the man slowly sliding down his chair and under the table, but the woman stared straight ahead.
The waitress watched as the man slid all the way down his chair and out of sight under the table. Still, the woman stared straight ahead.
The waitress, thinking this behavior a bit risqué and that it might offend other diners, went over to the table and, tactfully, began by saying to the woman "Pardon me, ma'am, but I think your husband just slid under the table."
The woman calmly looked up at her and said, "No, he didn't. He just walked in the door."
A man and a woman were having a quiet, romantic dinner in a fine restaurant. They were gazing lovingly at each other and holding hands. The waitress, taking another order at a table a few steps away, suddenly noticed the man slowly sliding down his chair and under the table, but the woman stared straight ahead.
The waitress watched as the man slid all the way down his chair and out of sight under the table. Still, the woman stared straight ahead.
The waitress, thinking this behavior a bit risqué and that it might offend other diners, went over to the table and, tactfully, began by saying to the woman "Pardon me, ma'am, but I think your husband just slid under the table."
The woman calmly looked up at her and said, "No, he didn't. He just walked in the door."
well,
It probably should, I will see just turns bap turns out. I have to make it fairly large so hopefully it prints good, so after I see how it prints I will know better if I can get "Tibs by bap" to fit and print good.
Just hate the waiting.
I have not been able to find one of these in that size.. 20 or 22 yes but not 21.
This is the only thing I have seen.
https://www.fasttech.com/products/1411/10005381/1565103
How about cutting the brass kick tube for the chi. That should work and the brass is easier to solder the neg to.
http://www.fasttech.com/products/1411/10005381/1490301
Last edited:
How about cutting the brass kick tube for the chi. That should work and the brass is easier to solder the neg to.
$2.31 Replacement Kick Tube for Chi You at FastTech - Worldwide Free Shipping
Hadn't seen that, that should work.
- Status
Similar threads
