VaporWerks rebuildable atomizer full specs and photos

[badinfluence357]

That's it, a lil ejuice, a lil elbow grease and your good to go!!....

 

[ragnarokstar]

Awesome. Will give that a try after I run this juice out!

 

[badinfluence357]

Waiting for you Stratus Dripper, 2 spots open so choose one!!...lol

 

[Skud]

J, is the reduced 22 still on the agenda? i'd love one, or two, or maybe three, haha.

 

[jherron]

It's likely , I'm focusing on the drippers at the moment

The first batch of drippers is almost done , everything is machined just gotta get everything assembled and packaged

 

[apbtdog1]

I want some drip tips

Sent from my SCH-I545 using Tapatalk 2

 

[badinfluence357]

Stratus 22 on bagua ti 18350

 

[Nach]

Who else had issues with getting their drip tips in their Stratus 22? Only me and one other?

Should I start wrapping some sandpaper around a pencil and have at it? Or is there a better way?

 

[apbtdog1]

Some of my DT's are tighter than others... Put a little joose on the rings they'll slide in there :thumbup:

Sent from my SCH-I545 using Tapatalk 2

 

[Nach]

All my drip tips won't even get far enough to reach the the oring!

 

[jherron]

you can send the cap back to me and i can enlarge the drip tip hole for you

All my drip tips won't even get far enough to reach the the oring!

 

[Nach]

you can send the cap back to me and i can enlarge the drip tip hole for you

Sure deal. Would you please PM me the address to send it to?

Thanks in advance!

 

[ragnarokstar]

Who else had issues with getting their drip tips in their Stratus 22? Only me and one other?

Should I start wrapping some sandpaper around a pencil and have at it? Or is there a better way?

I bought a goodsence vapor DT just for the 22 but it wont fit, looks pretty sweet on my KFL though. I thought about driving it in with a rubber mallet, but decided to it's best to take advantage of the situation and use my DTs that were too loose on my other attys.

 

[scoopbb]

woot, shipping notice!

 

[badinfluence357]

looking forward to sharing your joy, waiting patiently for J's creation, its. killing me!!!....lol

 

[bk78]

Scoop for your dripper?

 

[scoopbb]

yes sir....

 

[apbtdog1]

What kind of coil/wick setup is everybody running on your Stratus22? #wire, guage wire, how many wraps, etc.?

Sent from my SCH-I545 using Tapatalk 2

 

[Wingnut73]

Anybody know what size negative screw is used on the stratus 19? I bought one a couple weeks ago off the classifieds and one is missing. I'd like to run a dual coil setup but can't until I find one. I tried emailing vaporwerks a couple times and sent him pms on here with no luck. I know he's busy with the dripper so I thought I'd ask you guys.

 

[jherron]

screw is 2-56 , 1/8 inch length , extra screws and orings , are 3 dollars plus shipping