WHAT THE F*** IS WRONG WITH THIS PIECE OF SH**?!?!?!!!!?!?!?!?!?!?!?!?!?!?!
Ok, I've just about had it with this rta!!!!! I've build it
EVERY WHICH WAY more cotton, less cotton, cotton fluffed up, cotton flush, cut it this lenght, cut it that lenght, watched a dozen youtube videos and copied each of them exactly, HELL I even went as far as to take a piece of ofrf mesh and cut a tiny bit of it thinking that the idiots measured it wrong and if I use the entire piece it sits too high up and the airflow doesn't hit the middle, etc.!!!!
No matter what I do the result is always the same: if I'm lucky I get a few hundred puffs, if I'm unlucky I get a few dozen puffs and then it dry burns! Sometimes after the initial dry puff or 2 it will work ok(with just a bit of flavor loss) for a while longer, untill the second dry burn when it's pretty much game over!
I think I've got a couple more days of pain and misery left in me untill I
SMASH THIS PIECE OF SH** AGAINST A WALL!!!!!!!!!!!!!!!!!!! Any suggestions of what the F else I could try during these days?!
Thanks...
P.S. And no I'm not vaping at crazy wattages, 65w is where I hang around at.
P.S.S. And no I'm not using crazy high VG juice, lately I've been making my own and I do eighter 60-40 or 65-35.
P.S. And no I'm not chain vaping super long hits or sometimes, 2 or 3 hits(with a couple of second between each hit) lasting anywhere from 1 to 3 seconds each, then I put it down for a couple of minutes, rinse and repeat.
P.S.S.S.S.S. Yes, I'm sure I got the wicking right at least a couple of times, I mean I was able to SEE THE FREAKING BUBBLES!!!! so it was obviously wicking(right?), didn't matter....