Another way with the HERON...
This is the setup ill more than likely be doing. Seems a lot easier than trying to do that loop, i figured as long as i get a good amount of wick up into that fluff it should wick good
Another way with the HERON...
saw that video before, wish it was in english haha
Do you think if I doubled up 3mm silica and stuck that loop through the hole that should be a proper dimension going through the top cap?
I don't really see a benefit myself to using the topper with silica. You'll get better wicking from not using it because you'll be contacting the filler material and pulling juice to both sides of the coil.
I don't really see a benefit myself to using the topper with silica. You'll get better wicking from not using it because you'll be contacting the filler material and pulling juice to both sides of the coil.
If you want to run just one piece of 3mm folded in half so one end is a loop and the other is just two lose ends touching the fluff you can do that. Or you can triple it over so there loops at both ends. Or you can use Idabros awesome method as well.
What do you mean by sucked up exactly. The juice just sits in the fluff and then wicks in to the wicks as needed. It does not leak out of its own accord if your fluff density is good and you don't over fill.
could i not have 2 smaller strands of silica come through the topper hole and and spread each 1 in a different direction to sit in the fluff?
You could , but as I said before with silica there is really no reason to use the topper. You'll get better performance from silica without it.
I use the topper with one 'slightly controversial' build and that's it. My favourite build is no topper and loops of SnC yarn on both sides of the coil.
I guess i just misunderstood how well the fluff held the juice in. So this atomizer can be laid on its side for a period of time without causing problems? Or should it be straight up most of the time